- Navigation
Results 1 to 4 of 4
-
12-29-2016, 02:30 PM #1
LTXTech Sponsor
- Status
- Offline
- Join Date
- Sep 2010
- Location
- Red Oak Tx
- Posts
- 541
215/224 .533/.533 112 LSA cam and springs $350 shipped
215/224 .533/.533 112 LSA cam and Howards 98215 springs
$350 shipped in the US.
Mild idle, tons of low and mid range Tq while pulling to 6100 RPM.
Howards 98215 springs with dampers removed. Ready to install and uses stock retainers and locks.
Grteat for a mild F body or B body with stock gears and no stall.
Cama nd springs will work on cast iron haeds with 1.5 rockers (.501/.501 lift) and no machinework needed.
Lloyd Elliott
972-617-5671
nighttrain66@msn.com
-
12-29-2016, 06:56 PM #2
"The Rock"
- Status
- Offline
- Join Date
- Jul 2009
- Name
- Popo
- Vehicle
- 1996 Impala with the heart of the old camaro. 1993 Corvette..
- Location
- Shillington, Pennsylvania, United States
- Posts
- 61,345
LTXtech.com IS my drug...
OWNER/ADMIN
Our BIG MOMENT @ the 2012 LTXshootout
http://www.facebook.com/photo.php?v=521756391174175
1996 Camaro Z28: RIP 09/25/2016
1994 Trans Am GT: SOLD 05/2017
1985/1996GS clone: SOLD
1996 Impala SS H/C, LT, with true dual exhaust, 4.10s, lowered, with CPT trans, many cosmetic mods, and a whole lot more to come...
2002 Caddilac EscaladeL CAI, lowered, 6.0 , AWD..
-
12-30-2016, 10:58 AM #3
Lurker
- Status
- Offline
- Join Date
- Jul 2015
- Name
- Raymond
- Vehicle
- 1996 impala
- Posts
- 6
work on aluminum heads as well?
-
01-04-2017, 06:48 AM #4
LTXTech Sponsor
- Status
- Offline
- Join Date
- Sep 2010
- Location
- Red Oak Tx
- Posts
- 541
Yes, no machine work needed and still work with the stock retainers and stock locks but i would remove the stock seals and stock spring locators and then use a set of .060" flat shims under the springs and new seals.
The stock locator has a small area sticking up that fits pretty snug on the stock spring and the ID of these Howards springs are a lil smaller and the spring will not fit completely flat so removing the locatora nd using a flat spring shim will make it all work fine.
I can throw in the sealsa nd shims to amke it work if someone is wanting to use them on alu heads.
Lloyd
Reply With Quote
Bookmarks