95 harness on 94 engine

[beaver50]

Yes I know that.That the only ones I ever seen is the black and gray.But the one on this harness are different.They are just regular pig tails.They look like the pigtails for a o2 sensor or a MAF sensor.They push in.There bouble and have the same wires like the blck and gray.Except the single wire on has a wire running fro it too the other pig tails.The one gray pigtail that has 2 wire has 4 wires on this one.1 is the wire going from pigtail to pigtail like a jumper wire.The other one is a black ground.The other 2 orange and white with the stripe on it.Just like the gray wire has.I just cut the 2 wire the black ground and the ground.Then put my gray pigtail on it.The on the other one I just cut the jumper wire and the other wire.then I hooked up my black black pigtails.Both from my 94 harness.Does any body think this will work.Also on the harness I got not the 94.The trans plug that goes into the trans for mileage.Is different,its square instead of round and has 4 wires.But there are 2 wire rub with it.Too put my 94 2 wire plug on it.

[Injuneer]

Then someone altered the 95 harness. This is an actual photo of a stock 95 harness:

http://shbox.com/1/harness.htm

Very hard to follow your description of what you have. Could you post a photo? Is it possible the 95 harness came with something like the MSD adapter harness used with the MSD 6 box? That has a 4-pin connector that plugs into the stock dual connectors, and terminates in a single 2-pin connector at the coil.

https://www.msdperformance.com/produ...ses/parts/8876

As far as the transmission, a 95 A4 has a different number of wired pins in the main trans connector, compared to a 94. But that's a big round connector. The VSS connector to the sensor on the tailshaft of the trans should be the same 94 and 95. Compare the connector on your 95 harness to the one in the 95 wiring harness photo I linked above. VSS connector is in the lower right corner of the photo. If you click on a connector in the harness photo, it will open an enlarged picture of that section of the photo.

[beaver50]

The harness hasnt been altered.Its not set up for the 6 al box.But I ended up fixing my original harness and using some ends off of it I needed.Ive seen the pic of the 95 harness.I even checked the Roadmaster,impala and caprice harness.The all have the same coil connectors.But I do know this harness is a LT harness.It has the opti harness and everything connected right.But I cut it up so.I cant post pics.Ill see if I can post pics of the coil ends tho.