Dan's Money Pit NYTRDR

**Dan** · 07-04-2015, 09:44 AM

I actually did not get the relocations. I thought about it, but ended up not getting them.

**95 blackbird** · 07-04-2015, 11:18 AM

Definitely get them. Well worth it. Night and day difference in traction.

**Dan** · 07-04-2015, 04:24 PM

I'll see what mybank account looks like lol

**Dan** · 07-06-2015, 01:01 AM

I'm ordering the relocation brackets in the morning

My car no longer shakes on the highway. It feels about 100 times more stable.

I'm also pleased with how my car looks underneath. The floor pan is rock solid, there is hardly any rust. The only rust is on the rear end and axles, and it is just surface. The car came from Florida!

I think I'll just put my install of the headers in this thread.

**Dan** · 07-06-2015, 04:38 PM

So I have started the removal process with the headers. The driver side is getting stuck on the part of the steering shaft that comes out of the firewall. Bolts really were not that tight so.. I'm going to try and drip it out tomorrow when I do the passenger side.

Question:

Attachment 33494
uploadfromtaptalk1436218651148.jpg
This was connected to the AIR shit. Do I just cap it off at the manifold?

**Dan** · 07-07-2015, 03:26 PM

I'm going to run a AFR gauge and a vacuum gauge. Undecided on my third gauge. Are glowshift gauges any good? Anybody have experience with them?

**blackbirdws6** · 07-07-2015, 04:16 PM

Why not fuel pressure? No experience with glowshift personally.

**firebird_1995** · 07-07-2015, 06:54 PM

Originally Posted by DanDalessandro

I'm going to run a AFR gauge and a vacuum gauge. Undecided on my third gauge. Are glowshift gauges any good? Anybody have experience with them?

I'm running a glowshift vacuum/boost gauge. It's ok but if I was running na I would go with a mechanical vacuum gauge. @Arod6692 runs the afr and fuel pressure gauges and has had a lot of problems with the FP one. I believe they have replaced it twice. So far no issues with the afr gauge that I know of

**Dan** · 07-07-2015, 08:44 PM

Thanks for all your input everybody. Much appreciated. I'm not going to order any gauges anytime soon, just needed to know everybody's opinion on them before I did. I'm only a college student after all. I am going to get a fuel pressure, AFR, and vacuum gauge.

But anyways, it rained today so I didn't make any progress on the header installation. I've been sleeping half the day too so I didn't reclock my LS Steering shaft