- Navigation
Results 1 to 4 of 4
Thread: stock axle question
-
04-20-2014, 03:16 PM #1
InActive Member
- Status
- Offline
- Join Date
- Apr 2012
- Vehicle
- 1994 Camaro Z28
- Location
- Orleans,IN
- Posts
- 300
stock axle question
Are stock axles 28 spline? I'm planning on getting a mini spool and see there are options for 26 spline and 28 spline and even 30 spline. It is a 94 z28 by the way.
-
04-20-2014, 04:02 PM #2
InActive Member
- Status
- Offline
- Join Date
- Apr 2012
- Vehicle
- 1994 Camaro Z28
- Location
- Orleans,IN
- Posts
- 300
Also is the process that much more involved if I am taking a posi unit out instead of just the spider gears?
-
04-23-2014, 03:54 PM #3
LTXTech Sponsor
- Status
- Offline
- Join Date
- Feb 2013
- Vehicle
- 1998 Trans Am
- Location
- Greenville, SC
- Posts
- 147
If you are going to do a mini-spool, your best bet would be to pick up a rear end from a v6 because I think you must have an open carrier to install a mini spool. I could be wrong though.
1998 Bright Green Metallic Trans Am LS1/M6, Cam/Intake/Exhaust, Full Suspension, 3.42 gears, 30 MPG highway and 397 RWHP on untouched heads, 12.47@115 mph.... needs gears!
2011 Victory Red Silverado 1500 Z71 LC9 5.3/A6, Z71 appearance package, factory 18's, e85 warrior
Owner of Mickelson Performance, offering affordable LTX Tunes - mickelsonperformance@yahoo.com - www.facebook.com/mickelsonperformance
-
04-23-2014, 08:27 PM #4
InActive Member
- Status
- Offline
- Join Date
- Apr 2012
- Vehicle
- 1994 Camaro Z28
- Location
- Orleans,IN
- Posts
- 300
It looks like its the same setup minus having the plates with the springs and the clutches. It should be the same width across as an open carrier I would think. I'll have to do a little bit of research and see.
Reply With Quote
Bookmarks