- Navigation
Results 1 to 3 of 3
Thread: Monoblade porting
-
04-30-2011, 02:13 PM #1
Banned
- Status
- Offline
- Join Date
- Nov 2010
- Location
- North Port Fl
- Posts
- 264
Monoblade porting
I need some feed back on porting the opening for my monoblade. Ive got the gasket almost matched BUT im worried about the bottom part of the opening there is a hole now there. Will this mess with the flow of air going into the intake? If someone could post a pic of how they did theirs that would be nice. Ive searched and seen some people leave it and some people remove it(the middle bottom portion). Thanks
-
04-30-2011, 02:33 PM #2
Banned
- Status
- Offline
- Join Date
- Nov 2010
- Location
- North Port Fl
- Posts
- 264
Im sure i was very confusing lol here is a pic.
-
04-30-2011, 11:16 PM #3
Banned
- Status
- Offline
- Join Date
- Nov 2010
- Location
- North Port Fl
- Posts
- 264
no ideas?
Reply With Quote
Bookmarks