LS1 lid mod

[96lt1m6]

is it the lid on top of the base or the base itself that does not fit?

if you instal the base,upper shoud assembly it is tough to close the hood it will not latch. so adding the actual lid will definately not fit. you can instal the lid only with a bit of fabwork as most of us have already done.

[BLK95TA]

so this will work with a trans am with a WS6 hood, correct? and it works better than CAI? also cheper?

imo if you have your stock LT1 WS6 airbox, that is the best intake for an LT1 car. I added an oem hood/airbox to mine last year.

[JoeliusZ28]

if you instal the base,upper shoud assembly it is tough to close the hood it will not latch. so adding the actual lid will definately not fit. you can instal the lid only with a bit of fabwork as most of us have already done.

boo.

well then ill have to figure something out.

[ksmyss]

i know for a fact that the fostory lsi lid setup will NOT work under an ss hood.

[JoeliusZ28]

i know for a fact that the fostory lsi lid setup will NOT work under an ss hood.

well again, i think i have more clearance than a factory SS hood... but if it was no where even close to fitting then it doesnt matter.