rebuild

[Racecar1974]

This might not be the right place for this but I'm going to give it a whirl. I smoked some bearings in the bottom end but I don't know what ones yet because I haven't pulled the motor yet I've only pulled the pan and found the bearings. My question is if I caught it soon enough and can clean up the journals and there was no serious scaring can I just have everything cleaned and re-ring this thing and make sure all my clearances are good and roll with it. I'm only spraying it with a small hit, I think the reason it spun a bearing is low oil pressure but I'm not sure? Any info would be great.