I need a measurement!

[Pro-jection Eng]

Anyone who has their motor apart, can I get a measurement from the timing cover mounting surface (on block), to the front edge of the crank gear for the timing chain. I need a measurement for a single roller and double roller, preferably to the thousandth if possible.

Thanks,
Steve

[Puck]

Can you post a pic of exactly where to where? I can get you the measurements you need tomorrow morning.

[Pro-jection Eng]

I need a depth measurement, like lay a straight edge across the crank gear and measure to the block surface. I need this to make 4x crank reluctors for a double roller... single roller I suppose I can just use the factory OBDII reluctor I have sitting here. Thanks!