Summit is sending me a new one under warranty i guess. oh well. the tune is getting better. i am taking a pause on it though until i get the 42lb injectors back in as im probably gonna have to redo it all over again with them.
Printable View
Sounds good.
Sent from my iPhone using Tapatalk
Hey, Just checking on my New Jersey friends here. Any problems from the earthquakes?
Nolan
nah no problems beside everyone freaking out. my house is on the west side of the state about 15 miles from the epicenter, shook the shit out of it, and i work by nyc on the east side, think it was a little more nerve wracking at work because i run 2-11 story and 13 story buildings and you could definitely feel it. thanks
Sent from my SM-S908U using Tapatalk
Thank goodness it wasn't worse.
Nolan
No problems in central NJ south of New Brunswick..... moderate side-to-side shaking for about 35 seconds. But as west coast pros.... experienced the 6.7 Northridge quake in 1994..... by comparison, this one was pretty mild.
Glad ya'll didn't have a bigger issue. If there was an earthquake here, we'd probably get swallowed up in a sink hole in da swamp. LOL
Nolan
Hey Bud, Take a look at my new thread and throw an opinion at me.
Maybe Injuneer Fred might see it too.
Sorry for the highjack. LOL
Nolan
sooooo been a week and finally posting. took the car last Friday to the nighttime TnT at Island. da was poo at 2000ft and it was 80f and humid, but the car did well and everything worked. all na passes but it did a new pb for me on motor and picked up around .25 of a second and 3mph. that's promising, considering the afr was around 12.0. Best passes were leaving off idle and not footbraking it. car definitely feels different now with the single plane, you can feel the tq losses down low but up top it keeps pulling and pulling.
after that saturday evening was spent relocating the nitrous and fuel solenoids to the fuel rails, and making hardlines to the spray bar with 3/16 nicopp brake line.
have to get some more 6an redhorse 235 line to redo the fuel line from the holley blue to the fuel solenoid, also have to plot out my new nitrous feed lines as I want a quarter turn valve within arms reach so the nitrous isn't sitting against the solenoid in the lanes/burnout etc. https://uploads.tapatalk-cdn.com/202...037daefcea.jpghttps://uploads.tapatalk-cdn.com/202...f7a92bc195.jpghttps://uploads.tapatalk-cdn.com/202...e5d73ddea5.jpghttps://uploads.tapatalk-cdn.com/202...73e7e21396.jpghttps://uploads.tapatalk-cdn.com/202...68656d025a.jpg
Sent from my SM-S908U using Tapatalk