If I have to take mine somewhere to have something done I pull it on the rack my self.
Sent from my SAMSUNG-SGH-I547 using Tapatalk 4 Beta
Printable View
If I have to take mine somewhere to have something done I pull it on the rack my self.
Sent from my SAMSUNG-SGH-I547 using Tapatalk 4 Beta
this was the first time ever that someone that i dont know drive my car. but im going there tomorrow to look it over and check it out. the body was ok that i noticed. i had no front bumper on it. im having them check my rims and tires for balance and run down. than im getting a alignment. and see if there no damage on the trans. diff. and see if it drives fine. and hope it does. the frame is not bent far if it is but i haven't checked it out. but thats what i do for a living.
the only reason im doing this is because i need this at the tuner tueday night and have it in car craft in a couple weeks
I say contact an atty... Have him become ur middle man... They can pick upnthe tab for the atty too.. Or u can sue for that during litigation as well.
Also... I would use another shop for all of theb"check up" stuff when looking for damage....
Just my 2c.... May not be the cheapest way... But the best insurance ...
This is unbelievable...Im sorry that happened.
Co-Owner/Admin @ LTXtech.com
but i look at the car today and there is no scratches on the body from them and the engine tranny and diff are good fom what i could see by crawling around no scratches and dents on any. so we mesured the front rims and one is marginal when they did a runout. the worst spot was .056but u roll the tire and it wables to the right than wants to fall over. idk if i did that driving with the spool or what but it does now
the rims are out of spec. the most you want is .030 on lateral on radial. the radial will give you hop. like and egg and the lateral will make it so the done seat. and one of mine is .056 radial and .03 on the lateral. so its an egg and might not seat good. and i dont trust it going 150mph
yep sounds good to me are they this chrome and look like this? is so there cheaper than the ones on my carQuote:
Originally Posted by Fastbird
http://texas-speed.com/p-893-weld-ra...ar-wheels.aspx