7/16 rocker stud ....quick ?

[Bear1101]

Hi guys and gals.I recently orderd ARP 134-7103 7/16 rocker studs for my new NSA rockers. I was wondering if the heads would require machining for the new 7/16 studs or if they would screw right back in ? Thanks in advance for the help.:cheers:

Link to ARP 7/16 rocker studs

http://www.jegs.com/i/ARP/070/134-7103/10002/-1

[tleed]

they will fit

[96lt1m6]

No machine work required, you did get flat guide plates and hardened pushrods also,right?:secret:

[tleed]

yes flat guide plates will fit & just unscrew your old studs and screw in the new ones no machine work needed. hardened push rods is a must for hp engines

[gregrob]

What they said ^

The "7/16" portion is the part that the rocker slides onto. The part that threads into the helicoils in the head (yes the holes are heli coiled from the factory) is the same thread pitch and dia.

[Bear1101]

Nice !!! Im going to order some Trickflow 30400623-8 guide plates later this week and then measure for new push rod length and order them up. Thanks for all the replys and help. It is greatly appreciated.