Lines & Wires throught Fire wall ?

[95zsean]

I've done ALOT of searching for how to get the lines and wires throught the fire wall and can't find anything specific. Pics would be nice if you have then. The kit I have has a remote bottle opener and heater in the back. And I'm going to install the 685 box under the passengers seat and under the hood will be the fuel,N02, purge solenoidand TPS. I have a LS1 switch plate that has all the switches and I'm going to mod it to work in my console.
Sorry it sooo long but I want to make sure I have enough room to get all this stuff throught.
Thanks

[jakesz28]

I've pulled the ecm out and went thru the rubber grommet that the ecm wires go thru. Or the other choice is to find some rubber grommets and find the best location you can and add a hole. I've also ran the nos line thru the rubber grommets in the back of the trunk or the rear floor behind the front seats. the hard part about that is you have to pull some of the carpet up to get to them.

[hascet]

shbox has a good writeup
http://shbox.com/fw/Firewall_wire_feed.html

[95zsean]

Shbox!!!!!! I never thought to look at his site. I used it so much that I made a donation twice...
Thanks