Nitrous cam simulation????

[olimaro]

I was thinking about making the following adjustment put a set of rocker of 1.7 in the exhaust side to try to simulate a nitrouscam with the stock cam, these becaues it will take some time until i change for a set of cam/heads.
The shot that I am going to use is of 150 im being reading that with these shot is not much problem and the stock cam can handle it
My doubt is if i put 1.7 in exhaust and 1.6 on the intake it will show some gains or i just throw the complete set of 1.6 and dont go into more troubles
:peace2:

[Twisted Z]

We have found you may have some problems getting them to fit ;) I have a set of 1.7s we were going to put on my exhaust to get more lift but they would not fit ;)

BTW the push rods hit the guide plates. I ground them and then they hit the heads ;)

[n2ocamaro]

Just put on a complete set of 1.6s (don't forget the springs).

[olimaro]

thanks, i'll stay whit the 1.6 set only, and already have 2 sets of springs a hotcam kit and set of 986 compcams