PDA

View Full Version : easiest way to remove oil pan


tomsws6
08-13-2009, 12:32 PM
ok i need to remove the oil pan in my t/a. any suggestions?
Fastbird
08-13-2009, 01:54 PM
What work is being done? Does it have to come all the way out?
OutCast
08-13-2009, 03:03 PM
only way I've been able to do it without completely yanking the motor is to unbolt the motor mounts and raise the engine as far as possible with a hoist. Then loosen the k-member bolts to lower it a couple inches and it's just enough room to get the pan out. This is with an aftermarket k-member also. not sure if the same can be done with the stock cradle.
Chris
08-13-2009, 03:21 PM
Take oil lvl sensor out. motor mount bolts out. Jack engine till wont go any further. I didnt need to drop the k member when I have mine out
tomsws6
08-13-2009, 04:56 PM
might need to weld pickup tube or just et another pan
AChotrod
08-13-2009, 05:49 PM
The manual says it can be done with the motor in the car. Go grab a Haynes at AZ. Great book to have around anyways!!!
95formula383lt1
08-13-2009, 07:51 PM
i took the motor out on mine, it was to easy not to (pulled through the top)