'96 LT1 Parts For Sale

[HectorM52]

ALL ITEMS $10 OR LESS. ANYTHING LISTED AS $FREE PAY SHIPPING ONLY WITH PURCHASE OF $10 PART OR TWO $5 PARTS.


Guys, my garage is basically full due to having too many projects going on and hoarding too many parts. I've got to get rid of stuff. I'm going to slash prices hoping to get SOMETHING out of these parts. If I have anything in 60 days, it's all going to the scrapper.


ALL PRICES NEED SHIPPING ADDED!


MULTIPLE ITEMS ARE PRICED PER EACH!


BOLTS NOT INCLUDED!


(2) stock crankshafts that both need turned - mileage unknown - $10
(2) sets of stock bore pistons - one with 75k, one with 175k - $10
Water pump w/ ECT sensor - $10
Bad stock head (some valvetrain parts?) - $5
Full valvetrain set (valves, retainers, locks, rockers, studs, etc.) - $10
TPS throttle position sensor - $5 (need to find this)
IAC solenoid - $10
(2) kinda banged up oil pans - $10
Set of lifters (if I can find retainer clips) - $10
F-body starter - $10
B-body starter - $10
Water Pump Temp Sensor - $5
Head Temp Sensor - $5
(2) Pairs of OBD2 Knock Sensors - $10
Oil Dipstick w/ Tube - $5
Frame Mounts - $10
Motor Mounts - $10
Crank Balancer - $5
Windage Tray - $Free
(2) Camaro A/C Hard Lines - $5 (might only have one)
EVAP Solenoid - $Free
'94 Impala SS Cam - $5
Rear Main Seal Holder Plate - $5
Oil Filter Adapter for Cooling Lines - $10
B-Body offset oil filter adapter - $10
AIR Bracket and Pump - $5
AIR Hard Piping That Goes Under Motor - $Free
Oil Pan Rails - $Free
Oil Pan Bolts - $5
Opti Vent Tubing - $10 (I might be out of these)
EGR Solenoid - $Free
OBD2 Crank Position Sensor - $5
PCV Tube (needs new rubber hose) - $Free
F-Body Idler / Tensioner Pulley - $Free
B-Body Idler / Tensioner Pulley - $Free
Oil Pump Driveshaft - $Free
EVAP Solenoid - $Free
MAP Sensor (no grommet) - $5
4L60E Flexplate - $5
Oil Pressure Sensor Elbow - $5
B-Body Oil Pressure Sensor - $Free
Stock Timing Set - $5
Stock Hardened Pushrods - $5
Oil Filler Tube - $10


Ask me about bolts for longblock parts, I may have them (oil pan, timing cover, opti, motor mounts, TB, etc.)


SOLD
Water pump gear drive
Lifters & dog bones
Cam retainer w/ bolts
Rockers
Set of pushrods
OBDI F-body balancer hub
Rear main seal holder
Valve covers
Windage tray
Timing set
Throttle body w/ sensors
AIR pump w/ bracket
EGR diaphragm, solenoid, tube
EVAP solenoid
MAP sensor
IAT sensor
IAC solenoid
Opti vent tubing
Good stock head w/ valvesprings only
Intake w/ MAP sensor, NO fuel rails
(2) power steering pumps
B-body OBD2 hub for Balancer
'93 22# Injectors
'94 Timing Cover
Valve Covers
T56 Slave Cylinder

[Cross]

How many miles on the Opti I am interested.

[chevy42083]

BTW, he's a reputable seller. I've bought from him before.
Not to whore... I just know he doesn't have any posts on this forum... and the more posts you have the more reliable you are :secret::laugh:

[Cross]

Tell him to come online so I can paypal him and he can ship the opti lol.

[Cross]

I actually just bought Jdog's one in the thread below yours sorry.

[mpe331lx]

Interested in valve cover to throttle body hose.

You wouldn't happen to have any A/C lines? Specifically the main line that comes off of the compressor.

[97Snake]

I need a starter. If you have one.

[Divine02]

Do you have the engine wiring harness?

[941le]

The timing cover. Is it for the vented opti?

[tomsws6]

still got the oil pan?

edit: is the oil pan for a b body?

[HectorM52]

Back up!!

[59fordchop]

Just bought a motor because I think my bottom end may be going out. I'll get rid of the parts I don't need. Got the motor from a B-body today. Car had '87k on it when wrecked.
Make me an offer if my prices are too steep. I'm open to offers.
Hit me up on AIM if you want: username = HectorM52
CLICK ON PICS
Oil Pan - $50
http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8083.thumb.jpg (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8083.jpg)
PCV Tube (needs new rubber connector part) - $25
http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7944.thumb.jpg (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7944.jpg)
Pair of Knock Sensors - $40
http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7947.thumb.jpg (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7947.jpg)
Water Pump Coupler - $25
http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7952.thumb.jpg (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7952.jpg)

CLICK LINKS FOR PIC
F-Body Idler / Tensioner Pulley - $45 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7498.sized.jpg)
B-Body Idler / Tensioner Pulley - $45 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7946.sized.jpg)
Vented Opti 95k Miles - $75 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8256.sized.jpg)
Lifters & Dogbones - $60 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8091.sized.jpg)
'96 B-Body Cam - $60
B-Body Water Pump - $50
Head Temp Sensor - $13
Throttle Cable Bracket - $15 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6569.sized.jpg)
Oil Pump / Cam Gear Drive - $35 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6971.sized.jpg)
Oil Pump Driveshaft - $10 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7937.sized.jpg)
Water Pump Gear Drive - $20 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7934.sized.jpg)
Cam Plate - $20 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6973.sized.jpg)
Rear Main Seal Holder Plate - $25 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6975.sized.jpg)
Valve Covers - $35 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8233.sized.jpg)
Evap Solenoid & Switch w/ Majority of Hoses - $45
Ignition Coil - $20
Ignition Module & Heat Sink - $50
'96 Crank Position Sensor - $30 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8254.sized.jpg)
'96 Crank Position Cog - $30 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8253.sized.jpg)
AIR Pump w/ Bracket - $40
EGR Solenoid w/ Hoses - $20 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6570.sized.jpg)
EGR Diaphragm - $35 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6571.sized.jpg)
EVAP Solenoid - $25 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7864.sized.jpg)
MAP Sensor - $10 (http://s-seriesforum.com/albums/Parts-for-Sale/100_0930.sized.jpg)
Flexplate - $20 (http://s-seriesforum.com/albums/Parts-for-Sale/100_0933.sized.jpg)
Iron L99 Heads (Pair) - $50 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7925.sized.jpg)
Windage Tray - $25 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6966.sized.jpg)
'95 F-Body Pistons & Rods 70k Miles - $65 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7939.sized.jpg)
'94 B-Body Cam - $40 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8245.sized.jpg)
F-Body Alternator Brackets - $25 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8247.sized.jpg)
IAC Solenoid - $35 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_3087.sized.jpg)
Throttle Position Sensor - $10
Oil Pressure Sensor Elbow - $30 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6974.sized.jpg)
B-Body Oil Pressure Sensor - $20 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_6974.sized.jpg)
Starter - $45 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7941.sized.jpg)
Stock Timing Set - $40 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8250.sized.jpg)
Oil Pan Rails - $10
Oil Pan Bolts - $15
B-Body Offset Oil Filter Adapter - $50 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_8248.sized.jpg)
F-Body Power Steering Pump Pulley - $30 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7942.sized.jpg)
F-Body Power Steering Pump - $45 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7499.sized.jpg)
T56 Slave Cylinder - $10 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_1843.sized.jpg)
B-Body Power Steering Reservoir - $25 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7949.sized.jpg)
Stock Hardened Pushrods - $30 (http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7932.sized.jpg)
There's probably more I'm forgetting. Just ask.


DO YOU STILL HAVE THE POWER STEERING PULLEY AND IF SO IS IT SMOOTH OR DOES IT HAVE THE GROOVES IN IT FOR THE BELT?

[HectorM52]

Yes, I have one. It is smooth, no ribs. From an F-body LT1 motor.

http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7942.sized.jpg

[59fordchop]

Yes, I have one. It is smooth, no ribs. From an F-body LT1 motor.

http://s-seriesforum.com/albums/Parts-for-Sale/IMG_7942.sized.jpg

I'M BRAND NEW HERE AND I DON'T KNOW EXACTLY WHAT TO DO BUT I DO NEED A PULLEY. HOW MUCH DO YOU WANT FOR IT AND HOW WOULD YOU LIKE PAYMENT? I LIVE IN KALAMA WA. 98625 SO YOU WILL NEED TO INCLUDE THE SHIPPING TOO. WILL PAYPAL WORK OR WHAT DO YOU LIKE?

[HectorM52]

Email me. HectorMoore52@hotmail.com

Yes, I do paypal. Same address.

I'll do $35 shipped.

[59fordchop]

Email me. HectorMoore52@hotmail.com

Yes, I do paypal. Same address.

I'll do $35 shipped.

OKAY

[HectorM52]

Back up to the top with a revised list!

[McCauleyWB]

BTW, he's a reputable seller. I've bought from him before.
Not to whore... I just know he doesn't have any posts on this forum... and the more posts you have the more reliable you are :secret::laugh:

I have also purchased a number of items from Hector. Fantastic seller!