Fel-Pro 1406 Header Gaskets

[gregrob]

Are these any good? I'm going to be installing my headers soon and this is what came with them.

[lt1-xjs]

Lots of people run them including myself. As with any header just make sure you retighten the header bolts after a few heat cycles for a week or so.

[95formula383lt1]

thats what i got on mine, i've even re used them 2 times since pulling the motor and other stuff.

[gregrob]

thanks guys!

I want some percy split locks but might have to put them on later. Dont think they would get here in time!

[95formula383lt1]

the header bolts that came with mine have never came loose.

[gregrob]

Are the ports the right shape on these? Or does it not matter, they say for old schoold small block...

[95formula383lt1]

you need D port.

[95formula383lt1]

yes those are correct

[gregrob]

Yep, they say D port.

Thanx

[$hawn]

The fel pro 1470 is specific for the lt1.

[VendettaV8]

I used felpro's that i picked up from orillys for cheap....

[Bowtie4Life]

I've for the felpro's on mine too, no problems yet in 5 months with freezing temps a couple months ago and 90's the last two days. They're doing better than the copper ones I had, and better than the one's that came with my lpp's.