windsofthor
04-10-2009, 08:31 PM
Okay, I've had my car apart for close to a year now with general LT1 problems, as usual. I'm in the process of simplifying the wiring, and in a whole bundle of deletes.
I found a really great pin-out chart, and dotted specifically what my car has. I want to remove everything I don't need. The car is set up for dry weather driving, with the trim of a race car. So far I've deleted the Hvac system, EGR, AIR, run my fans off a manual switch, and some safety equipment. (airbags) My car is a 94, but has all the OBDII previsions installed from my 96 motor. I was thinking about reverting back to obd I since I can get away with all the emissions.
On my RED pinout I want to remove #'s; 9, 10, 11, and 14. I was thinking about NOT using pin #1 the crank sensor, because I would be reverting to OBDI. They didn't even have crank sensors. Is there anything else here I can do without?
On my BLUE pinout I want to remove #'s; 8, 10, & 24. Can I lose anything else here?
On the Grey/Clear pinout I want to remove #'s; 3, 4, 17, & 18. Deleting both rear 02's... Again, what else can I lose.
On the last Black connector I want to remove #'s 1, 21 and 23. Those are what atleast I know I want to remove.
http://img.photobucket.com/albums/v427/windsofthor/img8.jpg
I'm going to be afk for a while, but will be back later. Am I on the right track? I'm no expert with wiring, but no n00b either.
I found a really great pin-out chart, and dotted specifically what my car has. I want to remove everything I don't need. The car is set up for dry weather driving, with the trim of a race car. So far I've deleted the Hvac system, EGR, AIR, run my fans off a manual switch, and some safety equipment. (airbags) My car is a 94, but has all the OBDII previsions installed from my 96 motor. I was thinking about reverting back to obd I since I can get away with all the emissions.
On my RED pinout I want to remove #'s; 9, 10, 11, and 14. I was thinking about NOT using pin #1 the crank sensor, because I would be reverting to OBDI. They didn't even have crank sensors. Is there anything else here I can do without?
On my BLUE pinout I want to remove #'s; 8, 10, & 24. Can I lose anything else here?
On the Grey/Clear pinout I want to remove #'s; 3, 4, 17, & 18. Deleting both rear 02's... Again, what else can I lose.
On the last Black connector I want to remove #'s 1, 21 and 23. Those are what atleast I know I want to remove.
http://img.photobucket.com/albums/v427/windsofthor/img8.jpg
I'm going to be afk for a while, but will be back later. Am I on the right track? I'm no expert with wiring, but no n00b either.