PCMforLess

[Colossus]

How good are their tunes? Anyone on here have one?

[Fastbird]

Lots of people are quite happy with them. Very adept tuners.

[96LT1355Z28]

I've got one, well three actually! Right on every time and great customer service. :claps:

[Pony_Killer]

Bryan Herter over there tuned mine and I've had 0 probs!!

[hempkat94z]

He has tuned my car 4 times and has been spot on everytime. Great guy to work with.

[jaysz2893]

I have had Alvin do it 2x and been really good.

[Shon Herron]

They are good!

[GreenZ96]

I had 1 bad experience with a mail order. Been using madtuner since.

[PipesTA]

I had Alvin tune my car way back in the day. Great experience overall.

[BIGT94z]

I got a pcmforless tune and the car runs to rich for my liking

[harner]

Bryan tuned mine, great knowledgeable guy. No problems.

I got the tune after a LT install.

[KissMyWhtSS]

I was going to go with MadZ28 when I was looking at getting one. They're both good companies, Ion was just a little cheaper.

[BLOWNDFIZ]

Another positive vote for them. I've had my tune changed 2X and each time what I got back was EXACTLY what I asked them to do.

[JAKEJR]

Alvin's done two and Bryan's do others. Each was right on and I never had a problem. I highly recommend them.

Jake

West Point ROCKS!

[ThreeHonks]

I've never dealt with pcmforless so I cant really comment, but MadTuner did mine and it turned out great!

[LT1RUNNER]

PCMforless did a great job for me. If I ever need another tune I'm going back!!!

[Colossus]

Well, it came into today and I just installed it. The car idles 10x better, when I rev and start the engine it doesn't puff black smoke at me, its great!

Whats not great, however, is my inability to get the damn car into 1,3,5,6, and Reverse. What the hell could cause that? I'm pissed. I can't even go drive the damn thing! The blue and grey connectors to the computer don't look like they went in all the way. Could this be the problem? Why won't they go in all the way? The black and red wire harnesses plug in super easy.

[camarolt1]

can they tune for a turbo

[Z28pr0jekt]

Yes, I have a mailorder 2 bar tune going on my setup through them, and I have looked over and compared the parameters to DTS300zx's turbo tune on his LT1 and they are very close especially being a mail order.

Obviously you wont want that as your final tune, but it is definitely something good for the car to get started and be able to cruise around.

[Neil350]

Alvin did fine by me, I have his tune going in the new set up.

[mpe331lx]

Just put in an order with madtuner for 1hottcamaro's car. One of us will surely post up the dyno numbers afterwards.

[Colossus]

I unplugged the skip shift. Car runs like a raped ape.

[SROACH]

I don`t quite understand how this works. I have a Hypertech tune right now but I do not like it. I used it because I went to a 3.73 gear and it corrected my speedo and I have Jet Hot long tubes,MSD wires and cold air intake. I want to run a better tune. What would I need to do?:hmm:

[Colossus]

Get a custom tune or get a mail order.

[mpe331lx]

I don`t quite understand how this works. I have a Hypertech tune right now but I do not like it. I used it because I went to a 3.73 gear and it corrected my speedo and I have Jet Hot long tubes,MSD wires and cold air intake. I want to run a better tune. What would I need to do?:hmm:


1. Remove the hypertech tune by hooking up the tuner and restoring factory tune/settings.
2. get rid of hypertech tuner
3. Dyno tune. Or get a mail order tune by either sending your PCM to be re flashed, or they can ship you one on an exchange basis. Once you get the tuned PCM, box up and ship your old one back to them for the core refund.


BTW, I put in my order on thursday night for mine and recieved the PCM inj the mail today!

If I was not so damn busy getting the Cobra ready for the track, I would have swapped injectors, knock sensor, and installed the PCM.

I'll probably do it monday after work. I'll make sure to post up the drivability report ASAP.

[SROACH]

1. Remove the hypertech tune by hooking up the tuner and restoring factory tune/settings.
2. get rid of hypertech tuner
3. Dyno tune. Or get a mail order tune by either sending your PCM to be re flashed, or they can ship you one on an exchange basis. Once you get the tuned PCM, box up and ship your old one back to them for the core refund.


BTW, I put in my order on thursday night for mine and recieved the PCM inj the mail today!

If I was not so damn busy getting the Cobra ready for the track, I would have swapped injectors, knock sensor, and installed the PCM.

I'll probably do it monday after work. I'll make sure to post up the drivability report ASAP.

I am how much would that cost?:hmm:

[CALL911]

Mail order is around $100 I think. Check their website to be sure.

FWIW, tuning an FI LT1 car on the stock PCM with the output I have is extremly hard to tune. Bryan is the only guy I would ever trust with this as I am 100% confident he is the best LTX tuner there is. He tuned my Z, and it runes absolutely perfect.

I highly reccomend a dyno tune for anyone who is beyond bolt ons. I also had Bryan tune my LS1 car, which is also turned out amazing.

[gregrob]

My buddy and the previous owner of my car had a pretty bad experience w PCMFORLESS and Brian namely.

Ion from madtuner helped him straighten it out even though my buddy had been doing business w his competitor.

That's says a lot to me about Ion's character and I think he is an awesome tuner too.

Ion said it looked like they had Impala SS tables in my PCM which were more limited.

I'm getting a retune from Ion when I throw the headers on, then tweaking it myself w tuner cats.