236/246 .600+ lift cam

[cls-chicago]

i got spec'd out a custom blower cam from bullet and the specs are 236/246 and .615/.615 (maybe? it was .6 something), anyways heres the setup:

355 lt1
unknown ported stock heads
heads have 2.02 / 1.6 valves that are +.100 length
unknown ported stock intake
58mm tb
hooker long tubes, dual 3" exh
D1sc 3.25" pulley
9.5:1 or 9:1 c/r cant recall its written down at work

car is a 6spd, 4.30 gears, probably gonna run a 28" tall M&H tire on a 17" wheel.

gonna run meth injection
also going big FMIC


any ideas on this cam? too big? just right? looking to put down 600rwhp.

[devonsZ28]

thats a big f'n cam :metal:


i know, im no help at all

[cls-chicago]

haha that's about all i can say about it too

[stilltime]

What's the LSA?

[96lt1m6]

i hope that is on a 114 :D
it should definately run hard on the top end.

[95slowta]

That is a large f'n cam! I run the same cam with less lift and on a 110, when it ran it pulled hard as hell up top!