Can someone help with some trouble codes i got with datamaster?

[ben]

I finally got my car working again . It had a hydro locked motor. So I replaced it with a freshly rebuilt one.

But im having some small problems. Like my fans always turn on 10 secs after i turn on the car and they stay on till i turn off the car.

So i used datamaster to see if i can get a clue on what is going on.

Here is what I got from the Engine Diagnostic Codes window:


MALF 43: ESC Fail


And I got alot more in the Engine Status Bits window




Bit# 5: 1 = Oil Level Switch
Bit# 4: 1 = Oil Change Reset Switch
Bit# 3: 1 = Power Steering Pressure Switch
Bit# 2: 1 = Heated Windshield Request
Bit# 5: 1 = Transmission Mode C
Bit# 3: 1 = Transmission Mode A
Bit# 2: 1 = Perf Switch Pressed
Bit# 0: 1 = TCC Brake Switch
Bit# 3: 1 = Enabled Shift B
Bit# 2: 1 = Enabled Shift A
Bit# 1: 1 = TCC Enable
Bit# 1: 1 = Fan 2 Relay
Bit# 0: 1 = Fan 1 Relay
Bit# 6: 1 = Engine MALF's Occurred
Bit# 5: 1 = CAT Converter Overtemp
Bit# 2: 1 = Right O2 Ready
Bit# 1: 1 = Left O2 Ready
Bit# 0: 1 = Engine Closed Loop


And here is a screen shot on what was going on.
http://i6.photobucket.com/albums/y240/AdReNiLiNe/Untitled-1.png
Click on image for a bigger size


Can anyone help me understand this?

Thanks In advancED!!

[Fastbird]

Toubleshoot the DCT43. The fans are coming on because the computer is setting a DTC, and they default to on when a DTC is set.

[ben]

Thanks .

[djjab57]

can you tell me how you copied the datamaster page, ive tryed and cant figure out how
Thanks James B

[Fastbird]

can you tell me how you copied the datamaster page, ive tryed and cant figure out how
Thanks James B

Hit ALT and PrtSc (Print Screen) at the same time. Does a screen capture of the top window of your web page. Then past into a document and save as an image file.

[djjab57]

thank you