PDA

View Full Version : Harness Question


brarei200
03-09-2020, 05:40 PM
Anyone know what these harnesses are for? They are on the passenger side front near the alternator. Also, the 3rd picture, anyone have a diagram of this coolant hose? Mines rusted alittle.

https://i.imgur.com/XvveVjt.jpg

https://i.imgur.com/DTi93Iv.jpg

https://i.imgur.com/ruOig8H.jpg

https://i.imgur.com/8HMaO9W.jpg
SSlowBoat
03-10-2020, 10:20 AM
Anyone know what these harnesses are for? They are on the passenger side front near the alternator. Also, the 3rd picture, anyone have a diagram of this coolant hose? Mines rusted alittle.

https://i.imgur.com/XvveVjt.jpg

https://i.imgur.com/DTi93Iv.jpg

https://i.imgur.com/ruOig8H.jpg

https://i.imgur.com/8HMaO9W.jpgfirst pic ac compressor clutch, second inlet air temp, thats the steam line from back of engine.

Sent from my SM-N975U using Tapatalk
Injuneer
03-10-2020, 09:22 PM
For future reference:

Courtesy of Shoebox

http://shbox.com/1/harness.htm

http://shbox.com/1/95-97_hoses.jpg

http://shbox.com/1/heater_hoses.jpg
brarei200
03-11-2020, 08:23 AM
Anyone ever replace the steam pipe with AN fittings and braided lines with the motor still in the car?

Thanks for the replies
SSlowBoat
03-13-2020, 08:46 AM
Anyone ever replace the steam pipe with AN fittings and braided lines with the motor still in the car?

Thanks for the repliesThe factory steam pipe works fine. In the car im sure it could be done but would be a nightmare

Sent from my SM-N975U using Tapatalk
shownomercy
03-18-2020, 08:58 AM
It would be just as bad as installing the factory steam line IMO. But, if you are a purist, the AN fittings are not correct as factory is straight thread not taper.
SSlowBoat
03-20-2020, 09:48 AM
It would be just as bad as installing the factory steam line IMO. But, if you are a purist, the AN fittings are not correct as factory is straight thread not taper.

Correct

Youre "supposed" to take a 3/8" npt tap to them before installing the an fittings.

I dont think installing a stock one was all that bad, i just got new bolts from hawks
shownomercy
03-21-2020, 07:36 PM
I struggled with the double washer shens that GM dreamed up for that.
SSlowBoat
03-22-2020, 09:31 AM
I struggled with the double washer shens that GM dreamed up for that.ac seals from the dorman help section fit just tight enough on the bolt to stay on

Sent from my SM-N975U using Tapatalk
JOATMON
03-24-2020, 10:17 AM
I did a head job on mine in the car and had alot of trouble breaking loose the banjo bolts. I thought they were gonna snap. When I put it back together with new bolts and washer gaskets I was generous with never-seize. Also I'm pretty sure the threads are the same as (1/4" NPT) but they are straight not tapered. I came real close to converting it to pipe fittings and braided hose but then located new Ac Delco bolts and washer gaskets. Just general info FWIW
Nolan