Pushrod Lengths

[meissen]

Hey guys,

Under what circumstances would one need to get custom/measured pushrod lengths? I bought Comp Cam's hardened push rods and I've heard a few say "Did you measure the pushrod length?" :whistle: :doh: I just figured the regular height was fine.

[Z28pr0jekt]

Hey guys,

Under what circumstances would one need to get custom/measured pushrod lengths? I bought Comp Cam's hardened push rods and I've heard a few say "Did you measure the pushrod length?" :whistle: :doh: I just figured the regular height was fine.

If you have had the heads/block resurface... went with an aftermarket head casting, changed to a different kind of lifter.

Those are situations where you will need to check to make sure the valve geometry will be correct.

I have LS7 lifters and stock height worked for me (7.2)

[97lt1camaro]

Sorry to hi-jack, but if 1.6 RR NSA were installed with guideplates, would stock length push rods be fine?

[meissen]

Perfectly fine question to ask - that's exactly the same situation that I'm in. 1.6 RR NSA with guideplates and my heads were milled .01

[Green96Z]

With just 1.6 rockers, stock length is probably fine, but I would still measure them to be absolutely sure. If you plan on spending $80+ on hardened pushrods, might as well make sure they are the right length. The tool is only $20 from Comp.

And I would recommend Trickflow chromemoly PR's over Comp. They are exactly the same, except half the price.

[rpm4lalo]

I use the comp adjustable pushrod and color the top of the valve with a Sharpie then rotate the engine a bit and see if it wears in the center.