Cam Selection

[1968NovaSSLT4]

So I currently have an LT4 with the Hotcam installed. Reason I was running the Hotcam was to pass emissions. I no longer have this problem as the vehicle the motor is going into does not need to pass an Emission test. I am looking to change the cam to a larger one. Motor is 30 over with forged flat tops. Running 30# bosch 3 injectors. Also have a 3000 stall in the car. I am looking at either the cc467 or the cc468. Any input from you guys on which cam you would run? Car is a weekend cruiser. Valve springs are good to .625 lift so that will not be a concern.

[superspirit]

Call Lloyd Eliot, have him spec you a custom grind. the difference in cost is so small it's not worth it to run an off the shelf cam these days.

[BALLSS]

OP

agree with above post. Contact Lloyd for a custom grind.

If you just want a off the shelf, of the two XFI cams you noted I would get the 467. Understand the XFI cams have aggressive lobes so you need, and will need to change sooner than some cams, VERY good valve springs. I got 20k mi on a set of Comp 918's before one broke with my XFI, fortunately no engine damage

I have a XFI cam in my 383 and use the Lunati spring kit I got from Lloyd. Summit or Jegs also carry the Lunati spring kit 73925K5

[harner]

I think with a shelf grind you could be leaving power on the table. In order to maximize your setup, go with a custom grind. Lloyd is the man for the job. He's always been super helpful in random emails from me over the years.

[SSlowBoat]

Call lloyd, get a custom cam, and get lunati valve springs

Sent from my SAMSUNG-SM-G900A using Tapatalk

[1968NovaSSLT4]

Well is looks like to consensus is to go with a Lloyd for a custom grind camshaft. I just got an email back from the tuner and he said to also get a custom grind. LOL So I guess my next step will be to contact Lloyd.

[Vicious95Z28]

You can't go wrong with Lloyd, great guy!

Sent from my SM-S975L using Tapatalk