PDA

View Full Version : What tools needed to check PR?


383z
10-07-2015, 11:53 PM
Ok, I know I want to buy the Low Tension Valve Springs. http://m.summitracing.com/parts/pro-66793

But the real question is which pushrod length checker should I purchase?
I was thinking Comp Cams 6.8-7.8 length pushrod checker.
http://m.summitracing.com/parts/cca-7702-1
My question is this the best and easiest pushrod checker to use and is this a good size to buy? I don't think I'll go over or under 6.8-7.8.
This is for a 383 and AFR 210 heads.

Thanks!
96LT1355Z28
11-05-2015, 08:58 PM
That should be it other than a sharpie! Directions for checking PR length can be found on our page, there's a video and a step by step with pictures HERE (http://bdbracing.com/?page_id=375).
383z
11-07-2015, 01:47 PM
That should be it other than a sharpie! Directions for checking PR length can be found on our page, there's a video and a step by step with pictures HERE (http://bdbracing.com/?page_id=375).
Thanks for the conformation and the link!