Msd al6-2

[96z28SideSwype]

How many of y'all use this? I have one and my 2-step/launch control doesn't work the po said it was working and is willing to come help me work on it just wondering what maybe some simple solutions. I think I have a split in the wire right now but I'm not sure


Silver 96 Z28 SideSwype-DD
Green 96 Z28 NightMare-Drag car

[95slowmaro]

How many of y'all use this? I have one and my 2-step/launch control doesn't work the po said it was working and is willing to come help me work on it just wondering what maybe some simple solutions. I think I have a split in the wire right now but I'm not sure


Silver 96 Z28 SideSwype-DD
Green 96 Z28 NightMare-Drag car

send it in to msd. theyll fix you right up.

[96LT1355Z28]

How do you have it wired?

[1SlowFormula]

Wiring info would be needed to help since everyone does it slightly different, for example mine, a MSD Digital 6 plus, needs to 12v to the blue wire. I have mine setup that once a switch is in the closed position on the dash the brake switch works as my source voltage that flows up through a relay triggered by dash mounted switch then to the box. I use it this way in conjunction with my launch control (linelock) since putting a trans brake on a 60e is not advisable. It allows me to set turn on the 2step after the burnout box by flipping the switch, I use the 2step to appoach the second beam then lock my linelock and let the 2step rev. On a protree I release the footbrake, letting the engine sing, a hair before releaseing the linelock since it takes a bit to respond and have netted decent times that way...

[96z28SideSwype]

I'm not to sure on how it's wired I didn't wire it I know it is activated from a switch I have my lineloc attached so when I push the button it turns on I'm sorry I don't know much else car is a m6 also


Silver 96 Z28 SideSwype-DD
Green 96 Z28 NightMare-Drag car

[ZOHAN]

I have one. All it needs is an input signal. Make sure you have power entering and leaving your switch...

Making you silky smooth...

[96z28SideSwype]

I know the switch works because my line lock works I just think from point a the switch to point b the box there's a split but I'm not sure if there's another think I can check before I start changing wires


Silver 96 Z28 SideSwype-DD
Green 96 Z28 NightMare-Drag car

[ZOHAN]

Well its just one wire. I believe the blue one from the msd box. Trace the one wire and check it out

Making you silky smooth...

[96LT1355Z28]

Is the wire that activates the 2 step getting power when you activate it?