PDA

View Full Version : Once again no start



Jurstin86
12-22-2013, 09:34 AM
Y'all know iv had this problem before. Car has new opti, new coil, new plugs and wires, new icm, new icm pig tail, new coolant sensor. U can hear it kick one time when trying to start it after that just turns over. Fuel pressure is 50# key on falls to 45# and stays. Car also has msd 6al, 2 step and timing control. Any other ideas?


97 z28 M6, 58mm, 36# injectors, 340gph pump, lt's, ory, tf elbow, 1.6rr, xfi292, 150 shot. Stock bottom end, tuned by lttuner.com

Jurstin86
12-23-2013, 08:15 AM
No one!? It's only a cold weather issue


97 z28 M6, 58mm, 36# injectors, 340gph pump, lt's, ory, tf elbow, 1.6rr, xfi292, 150 shot. Stock bottom end, tuned by lttuner.com

ginoz28
12-23-2013, 09:14 AM
Did you check for spark at the coil

Sent from my PC36100 using Tapatalk 2

jimmy21480
12-23-2013, 11:18 AM
What brand opti did you install? Are there any DTC's present? Some DTC's do not illuminate the "check engine light" but still prohibit the engine from firing.

popo8
12-23-2013, 12:30 PM
Maybe also link ur previous problem thread here in ur initial post.....so we can look at that as well.

LTXtech.com is my drug.

Jurstin86
12-23-2013, 01:21 PM
Now I know...it's a accel opti. I was in a bind and had to go with it. Coil is new. Icm is new.. When it warms up outside it will start. Can't read the DTC's cus of the obd1 PCM swap. And my aldl cable hasn't came in yet but the light is on.


97 z28 M6, 58mm, 36# injectors, 340gph pump, lt's, ory, tf elbow, 1.6rr, xfi292, 150 shot. Stock bottom end, tuned by lttuner.com