Gauging Interest: Ported LT1 heads w/shaft mounts

[paul95z]

Stage 2 ported by a local shop. Flow in the 270s at .600. Can provide full flow sheet if enough interest. 54cc chambers, t&d shaft mount rockers, 600 lift springs. Set up for solid roller, pretty sure a HR would work to since the springs arent too stiff. Just completly reworked, springs, valve guides, seats etc all new. Took my car to 11:01 at 121 on motor with 93 octane pump gas. Can get pics and all that good stuff as needed. Just checking to see if they will sell for now.

Would like $1200 shipped ready to bolt on.

[Z28pr0jekt]

how much would it be without the shaft mounts? I'd imagine that would take a good bit off...

[paul95z]

I need to check a couple things and Ill get back to ya. Me keepin the rockers is an option though.

[MeanGreen94Z]

i want the rockers pending they will fit AFR's or would you possibly want to trade this setup ( i know i may sound stupid) for a set of AFR 210cc's plus a little cash ...they are new

[paul95z]

Sent a pm Mean