New rear end and suspension.

[jseal-57]

Well I I finally got the parts to swap out my rear end. I'm going with a moser 12bolt with 4.10 gears. Also going with umi suspension parts. Lca, panhard par, drag sway bar, torque arm with drive shaft loop, lca relocation brackets, 3 point sfc, and qa1 coil over shocks. Also changing out my fuel pump while I have the rear end apart. And install a nitrous outlet kit. Prob run a 100 shot. Mickey Thompson drag radials 275/50 15 on the back and Mickey Thompson sportsmans 26x6 15 on the front and there all mounted on weld pro stars. Also installing under drive pulley set, msd coil, msd plug wires, msd digital 6 plus ignition, and msd opti. And putting on new brakes all the way around and line lock on the car.
Right now everything is outta the back and I'm just going to get everything done on the back this weekend and work on the other stuff next weekend. I'll put some pics up tomorrow night.

[jseal-57]

Here are the rims and tires. 20828

[jseal-57]

Some more pics. 20834208352083620837208382083920840208412084220843

[SWells]

I'd be happier than a kid in a candy store if that was in my garage. Subscribed, gotta see the outcome.

[Mystery Bird]

Christmas in June.

[1sickta]

Pretty much the same setup as mine. You will like it. I loved my drag swaybar.

[jseal-57]

do you have any suggestions on what to set the suspesion to? i got most of the rear in but the shocks are looking a little stressed but the rear is still sitting pretty low in the car, and i think they will look better once i get the rear back to where its normally sits in the car. the only thing i really need is pinion angle and how far back the axle should sit? thanks

[1sickta]

On the pinion angle I set mine at -2*, on the LCA mesaure your stock ones for a staring point. I set my drag bar up as the instructions said and never had to mess with it. Set it on the street setting. As far as the coil overs go you just need to have your ride height where you want it. Once all that is done take it in for an alignment.

[jseal-57]

ok thanks. thats what i did with my LCA and thats what i thought the pinion angle was going to be. hoping to get everything on the rear done this friday and if need finish it on sunday. going to a SRT10 dyno tune in the city with dad and his supercharged SRT10 ram reg cab. last time it put down 600whp.

[jseal-57]

Anyone else find it hard to get the calliper brackets on? And what did you do to get the tight? I had to make a custom tool to get it pretty tight. 2100321004

[jseal-57]

Well got everything installed and it all looks great. Can wait to try it out 2104321044210452104621047210482104921050

[1sickta]

Ready for some abuse. Looks killer!

[jseal-57]

i think so. i just need to get my nitrous kit installed then off to the track for so testing and tuning. try to get everything ready before i tear the frontend apart this winter to do the k member and build my new motor and give the car a paint job. shes finally coming together nice.