How much power should it make?

[jderry]

I had my car dynoed once before.
Then it only had:

K&N CAI
Trickflow elbow
SLP air foil
Pacesetter longtubes
stock catback
madz28 tune

It made 267/305 on the Livernois Motorsports Dyno
With this setup it was running 13.3x 1.88 60' @ 111-112 mph

Now it has:
K&N CAI
Trickflow elbow
SLP air foil
Pacesetter longtubes
3" x pipe with Dynomax Bullets dumped at the axle
LE 228/236 .576/.571 110
Comp 1.6 rr
10% underdrive pulley
All MSD ign
Stock heads milled .20
GM .26 head gaskets
Compression right near 11.8:1 if my math is correct
Street tune

Now the best time at the track is 12.53 1.74 60' @115-116 mph

That is with the same tire and transmission.

[Mystery Bird]

Are you running a six speed?

[firebird_1995]

I'm gonna say 320

And pushing the limits of the stock injectors!

[jderry]

4l60e

It now has a 3600 stall in it, have not had it to the track since.

[jderry]

I am wanting to get it ET as low as possible without anything major done, thinking about putting it on a little diet and better suspension stuff.
I am also thinking about a dyno tune after some better injectors.

[blackbird1084]

Where do you race at? I had umi lca's, dd subframe connectors, edelbrock torque arm (all previous non-adj), umi relocation brackets, qa1 coil-overs f, qa1 single adjustable rear shocks, I removed the front sway bar and was cutting 1.5's on a 275/50/15 mt et street dr.

[jderry]

Milan Dragway, those 60' times were with a stock converter.
I have stock decrabon crap up front and gas-a-just with stock springs in rear.
T/A is stock

[blackbird1084]

Those are good 60's with a stock convertor. The best 60' I got running stock springs, stock struts, stock shocks was 1.73 I had a 3500 tci same rear suspension and 245/50/16 nitto 555r's. it wasn't consistent though. I had to ditch the front sway bar to gain consistency. Your car is pulling great mph though.

[Mystery Bird]

FWIW I'm still running stock original springs and shocks on all four corners, running mid 1.5's 60ft and low to mid 11's...for now.

[jderry]

I have a 1LE front bar, I do DD the car in the summer, is no front bar a bad idea?

[blackbird1084]

I notice very little difference dding mine after taking the front bar off. Mine had the 1le as it is a WS6.

[ScreaminRedZ]

I might have missed it, but did you mean 101-102 mph?

[CALL911]

I'm gonna say it should make 315-330 RWHP.

[SlickWilly]

I wish I could call a cam not major.