View Full Version : hoping to get 300 rwhp
dakota
03-23-2011, 01:59 PM
since the weather is turning around im looking to get my car out, tuned and dyno'd. I am hoping for 300 rwhp; fresh motor 3,000 miles with a comp cams 502 kit, and bolt ons - CAI, headers, ETC.... Do you think it will at least be around that goal?
BIGT94z
03-23-2011, 02:50 PM
m6? i know guys running the cc502 through a m6 make anywhere from 340-350 tunes to the tires
black heartbeat
03-23-2011, 03:21 PM
I think you can easily hit that or more like 310 320
I'm with Travis on this one. Should be able to do upwards of 350whp.
It all depends on the tune though. Those stock heads (I'm just assuming) are hurting you the most.
doferrell
03-30-2011, 03:26 AM
i agree. w/bolt ons and a stock bottom end is about 270, so w/the cam u should easily get over 300 rwhp... unless u have a really bad tune and it doesnt run right lol. hopefully that wont happen.
jaysz2893
03-30-2011, 06:10 AM
is is very possible depending on if you have a M6 or an A4, your rear gears, and the dyno. I was totally stock internals and had the following boltons (mods):
(car is M6 with a 3.23 rear)
LT headers
Underdrive
52mm TB
TB Bypass
open cutout at the Borla
!Cats
!AIR
!EGR
MSD 6a
MSD coil
MSD opti
mail order tune
Ultra-Z Ram Air (similar to Firehawk)
on a Dynojet running very lean I made 314RWHP/350RWTQ I had 2 injectors on the way out and couldnt got WOT cause my TB connector clamp was hitting the TB linkage (DOH!)
http://www.fquick.com/images/vehicles/full/2253321036.jpg?1276598702
Before having the bigger TB, LT's, and Catback i did a few pulls on a Mustang Dyno. I made 304RWHP/340RWTQ
http://i4.photobucket.com/albums/y136/TheKeenans/225311197.jpg
And bone stock on a Dyno Jet I made 267RWHP/314RWTQ
http://i4.photobucket.com/albums/y136/TheKeenans/IMG_3132.jpg
You should have no problem making around 350 RWHP like i said depenifn on trans and gears. As you can see I left a lot on the table with the lean and jammed throttle runs. I never got to dyno with the injectors and throttle fixed befroe i had to pull the motor. I think i would have been around 320ish RWHP and 360ish RWTQ.
Good luck with your goals and make sure you check the little things like the tune, the fuel delivery, and the throttle (LOL).
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.