Raced several Terminators this summer, Tons of vids!

[green96ta]

Here is the first vid from this summer. This 03 cobra has full exhaust, pullied, tune, tb, 456 gears.

http://www.youtube.com/watch?v=nFkXWLvNFuk

Here is the second, it is edited by my friend, vid taken from his iphone 4. His girl called and interrupted the vid, but you get the gist. His car is much faster than the first I raced. His mods are basically the same but he has 373

http://www.youtube.com/watch?v=tk5uXawKzdE

This race is like the first, only this car has a ported blower and puts down north 515 rwhp. My strategy was different on this race, I manually put the car down in second and then after WOT began I put it in D. This way I didn't have to wait for the kick down, As you can see, when I went wot the torque from the nitrous was an instant car length on him.

http://www.youtube.com/watch?v=EATJJttedXM

[ws6nighthawk]

those are some great kills man. congrats! what mods have you done since then?

[green96ta]

those are some great kills man. congrats! what mods have you done since then?

355 with forged pistons, stock rods with arp, stock crank, good bearings, cnc pored heads, cc306, and will start with a 150 shot and prolly work up to 200 shot. ill also be stepping up from a 2500 stall to a 3200-3600 stall.

[zooguy]

i know you a few more mods than i do ... but can you compare and contrast the two cams? (likes and dislikes ) ... i dont want to do a internal motor ... which one makes power where? cause i plan on doing a 3200-3600 stall

[green96ta]

well i havent ran the cc306 yet. still building the motor. However, with the stock heads and cc503 i had in the those races that cam is amazing with stock heads. Now im gonna be running 200cc cnc heads and the cc306 im sure the car is gonna be a monster. IMO i would never run anything other than the cc503 on a stock longblock car.

[zooguy]

not trying to high jack:oops:

where does it make power? (high or low) do i need a baby stall or bigger one like 3600

[green96ta]

not trying to high jack:oops:

where does it make power? (high or low) do i need a baby stall or bigger one like 3600

the cc503 is a great low to mid range cam with stock heads, i would say you should go with a 3200 unless your planning to go bigger than cc503 later

[zooguy]

sweet

[TSAEB]

crazy i need to show my buddy this vid.....claims his cobra(pretty much the same mods just minus gears and ported blower) can walk my project build....383 full bolt on and big spray.....mmmm...or maybe i wont show him this vid.....:hmm: