Clutch pedal is froze up!

[Slow 5_seven]

Im in the middle of doing a LT1/ T56 swap into a 94' V6 A4 camaro. I finished mounting the clutch master cylinder into the firewall. I then put the rod onto the clutch pedal and and there is no clutch pedal movement! The slave is not hooked up yet, if that matters. Help Im confused.

[Paulster2]

Don't try to push on the master until you get the slave installed. I believe you can cause damage to your hydraulics. Test it after you have installed the slave and I think you'll have a different result.

[Fastbird]

It's not going to move until you get the slave connected to it. You're good for now.