PDA

View Full Version : SVO 30lb Injectors


Neil350
10-17-2008, 02:32 PM
Looking at a set of Red Top 30# SVOs (part #M-9593-BB302), will these be a direct replacement for my stock 22#? I'm starting to collect parts for my 355 build, the car already has a Walbo 255LPH pump in it. The set up will probably be around 385RWHP or so, nothing crazy, CC306, Ported LT1 Castings and will have a wet nitrous kit jetted around 150-175HP.
Tony Shepherd
10-17-2008, 02:43 PM
Yes those will be a direct replacement. They are the EV1 style and work well.:peace2:
Louvit
10-17-2008, 06:09 PM
I just put them in my 93....
Neil350
10-17-2008, 08:59 PM
Thanks guys
Tony Shepherd
10-18-2008, 08:08 AM
When you install them....the injector clips will not go into the bottom groove. You will need to pull the injector down far enough out of the rail to install the clip in the upper groove. Go it?
Neil350
10-18-2008, 04:40 PM
I'll take note of that, is there a reason you ran the 42lb injectors over these in Kyles Formula?
Pony_Killer
10-18-2008, 05:50 PM
When you install them....the injector clips will not go into the bottom groove. You will need to pull the injector down far enough out of the rail to install the clip in the upper groove. Go it?

Is this with the older style 30's? I have those newer style and noticed that I couldn't use the clips also..I just made sure they were snug and kept an eye on them until I could figure out what to
Neil350
10-22-2008, 03:17 PM
I bought a set of the older style where the top is red as oposed to the entire injector body.