rims for a 86 bird??

[Silver Bullet]

i hae a set of 17X9.5 zo6 replicas i would liek to put on the firebird i am goign to pick up. what is all need to do it or will they fit on wiht no spacers needed?

also i saw in someones sig that they had a 3rd gen maro with zr1s on it. i have a set of them as well 17X9.5 fronts and 17X11 in the backs could i put these on to??

thanks guys and pictures of 3rd gens wiht these types of rims(any type of rim like the z06 or zr1) on them would be much apprecaited :hmm::hmm::secret::secret:

[DMBlack]

I am running a 2" spacer I bought on Ebay to run my ZR1's on my third gen. After I did my LS1 front brake swap the 275/40r17 tires on the front started rubbing a bit, so I think that I am going to step it down to a 1.75" spacer. My wheels are 17x9.5 for now but I would think that the 17x11 will need the same 2" spacer.

[Silver Bullet]

so a 2 spacers to run the 9.5 on the fronts and none is need to to rn the 9.5 on the back? an ddo i have to buy longer studs??

[DMBlack]

I used to have a fourth gen rear end so I didn't need a spacer, but now that I am running a third gen differential I have to run a 2" spacer in the rear also. It uses the stock studs with the Ebay spacers. I had to switch rears again because I bought a set of Telstars in third gen offset.

[Silver Bullet]

do you have a link to the spacers you bought? and i shoudlnt have any problems running the 9.5 on the fronts unless i change the brakes??

so i can swap a 4th gen rear into a third gen?? might just do that