FS: heads/cam

[96LT1SS]

Going to a new setup so this one has to go, Its a custom grind cam by bret bauer that specs out at 232/232 .608/.608 on a 108 lsa the heads are very similar to the LE3 which have 2.05/1.60 valves and these have been milled and the chamber are now at 55cc. They flow 284/225 at .600'' They were ported by mike blackstone and will come assembled with beehive springs and titanium retainers. Looking to get $1700 obo

[sinistr]

i just have a quick question for you .. did you have any issues running those heads on your block if it was a stock bottom end .. i want to put my le3 heads on but not sure if they will not tap the pistons as my duration is something like 23x-24x ...but you also have way more lift that me .. i think with a thicker gasket i will be fine though ... i know i need to check my ptv clearence ...

[96LT1SS]

no

[1badeagle]

Who did the head work?

[96LT1SS]

mike blackstone

[joelster]

i just have a quick question for you .. did you have any issues running those heads on your block if it was a stock bottom end .. i want to put my le3 heads on but not sure if they will not tap the pistons as my duration is something like 23x-24x ...but you also have way more lift that me .. i think with a thicker gasket i will be fine though ... i know i need to check my ptv clearence ...

I run the XFI468 cam on the stock bottom end. 242/248 .584/.579. Have about 15,000 miles on it so far, rev it to 6900 here and there. Stock gasket for me.

[96LT1SS]

well whats your lsa, and my lift is quite a bit higher. I have taken mine to 6800 everytime

[PHINES LT1]

how much for just heads? thanks

[96LT1SS]

1400