results

[bmxbandit]

Hit the dyno for the first time (LPP LT headers, off road Y, borla catback, cai) and the car put down a baseline of 280hp & 303tq. After tuning I was able to walk away with 292hp & 316tq. So close to 300! Will a set of underdrive pullies enable me to hit the mark?

[TA the destroyer]

man nice numbers! if it was me i wouldnt do pullys i would do some 1.6 roller rockers. then youll probely hit 300 and your valve train will also be more stable at higher rpms. but thats just me.

[KissMyWhtSS]

Nice, congrats. I figure that's right about where I'm at too, but don't have a dyno sheet to prove it. I might dyno it sometime soon, I want to see where my a/f ratio is at to determine if I should get a tune.

[Blkdragon]

Good gains from the tune. Is your car an m6 or A4?

[bmxbandit]

Car is a M6.

[ScreaminRedZ]

Very nice numbers! I agree with TA the destroyer, throw some 1.6 rockers and a set of valve springs on there. An electric water pump would probably free up some top end power as well.

[Fixxer99TA]

Very nice numbers! I agree with TA the destroyer, throw some 1.6 rockers and a set of valve springs on there. An electric water pump would probably free up some top end power as well.

Both of these togeather should definitely get you AT LEAST the extra 8hp you are looking for.

Nice #'s by the way!

[razor02097]

It's been over 5 months... maybe he already did some stuff to get up to 300.

OP you have any updates?

[jaysz2893]

Still not bad numbers. I broke 300 with out LT headers and exhaust on a Mustang Dyno.