used Edelbrock Lt1 heads

[catchmyz]

used complete Edelbrock Lt1 heads. Heads saw less then 2000 miles before engine was torn back down and I went a different route on the rebuild. Engine was never over heated. Before being installed on engine, heads received a 3 angle valve job,Teflon HP valve seals, spring pressures were checked and shimmed accordingly, and they received thermal coatings from calico coatings. Coatings included combustion chambers and exhaust ports, head of exhaust valves and combustion side of int valves with there CT-21 coating. Heads are assembled and include springs, shims, seals, retainers and locks, screw in rocker arm studs, but combustion chambers do need to be cleaned before being reused.

54cc combustion chamber
170cc port size
pics available

asking
$850 neg + shipping

[bricez28]

anyone know how much power these would make?

[catchmyz]

When they were on my Car it dynoed 300, down a cylinder(faulty PCM), through a high stall automatic, cam was only 502 lift. Sure Edelbrock can give you the flow numbers.

[joelster]

iirc they flow right around 245ish cfm.

[catchmyz]

one last to the top