FS: TPiS ZZ409 Camshaft

[BlackWidowSS]

This is a TPiS ZZ409 Camshaft that came out of my 1997 LT1 Camaro. It is in GREAT condition and would be great for a cam only, or mildly upgraded LT1!

Specs are 226/226, .525/.525, 112 LSA

I just want it gone so I will sell for $125.00 shipped!

PM me if interested!

[Jay]

what kind of power did you make with the cam?

[Jay]

also a sound clip would be nice, im interested.

[BlackWidowSS]

Here is a video.


http://www.youtube.com/watch?v=pJeS1h8kPT4

Also I dont know how much power because I never had it dynoed with the cam in. The setup I had wasnt working like it was supposed to so I decided it was time for a new setup altogether. It wasnt the cam, but a combination of other things that just didnt jive right. i.e. heads/cam combo wasnt researched before the guy set it up. I bought it that was. It is a great cam but It wasnt for the heads that were on the car at the time.

[Jay]

im aiming for around 330-350 wheel with some very small head work and a cam, with 1.6rr. Do you think I could hit that with this cam?

[BlackWidowSS]

Definately. Small head work and 1.6's should go great and you showld crack you HP ranges if not a little over.

[BlackWidowSS]

***bump***

[Silver Bullet]

what was all doen to you rcar when you had that cam in it.

[BlackWidowSS]

AFR 187cc Heads(2.02/1.65, 54cc chamber), Dynatech LT Headers, 350 bored .040, Port Matched Intake, MSD 6AL ignition control, MSD Opti Cap/Rotor, MSD OTVC 8.5mm SP Wires, 3" catless exhaust, 52mm TB, 30# SVO Injectors, CC .600 lift springs, Crane Cams Gold 1.6 SA RR's, Trick Flow Chromemoly Pushrods, Corvette LS7 Lifters

[miller09]

do you still have the cam?