What lifters and Pushrods, what to get?

[JJRRACING]

Ok, My CC503 has arived, Canton Valve Covers are here, Scorpion 1.6 Rockers, 32LBS injectors are on the shelf waiting for two more Items,

Lifters and pushrods.

What do I get. I dont want to go crazy. Would stock lifters and pushrods do the trick or should I step up a notch or two. What leingth pushrods do I get and where is the best place to get them.

Thanks in advnace for any help.

[devonsZ28]

ls7 lifters are pretty affordable, and your going to want to measure the push rod lenth for after market pushrods, you can get ls7 lifters and a push rod lenth checker from any place like summit or jegs

[harner]

ls7 lifters are pretty affordable, and your going to want to measure the push rod lenth for after market pushrods, you can get ls7 lifters and a push rod lenth checker from any place like summit or jegs

I agree with this. I am doing a cc503 swap as well and going with the LS7 lifters. I'm hoping to get the PR length after my heads are set up. I picked up a Trick Flow depth checker for like $20.

[95formula383lt1]

on 2 different builds i did different things 1st one i used comp cams lifters, and competition cams 7.200 hardened push rods. the other build i reused the stock lifters after checking over them very well. and then re used the push rods too they were the heavier ones was told 94 had hardened ones don't know if its true or not. both of them have cc306 cams one is a DD and one is a project the DD has ported stock intake an heads as well.

[JJRRACING]

Thanks for all the info Guys...

I ordered my LS7 lifters today and a borowed a pushrod checker from a loal engine builder...