Borla or SLP LM

[justatoy]

Ok guys, I have a Borla catback sitting in the garage and a SLP LM on the car now. My question is would it be worth while to swap the two. I am looking for more of a deeper sound than I currently have and was wondering if the Borla is deeper or close to the same. Thanks in advance.

[Masoch]

Is this on an LTx? If so I'd go with the Borla, it has a bit deeper of a noise. On the LSx, assuming you don't have headers I'd pick LM. Make sure to not let them weld it incase you don't like it.

Its all a matter of taste in the end, a good place to go is LS1sounds.com and check them out. LTx does sound a bit different than LSx, seems to have an overall deeper rumble.

[Fixxer99TA]

Borla might be a little deeper, but not by much. If you think you will like it more then go for it, its all up to you.

You will notice a difference, but less then you think... At least with the borla you can control the noise level/sound if you have the plates.

[justatoy]

Yes, it is on a LT1. I think I will do it for something a little different. Currently I have shorty headers on but hope to put LTs on this winter.

[Fastbird]

I can attest that the borla does NOT have the rasp of the LM. But for god-awful dead wakening sound, LM all the way.

[Camaro_94]

I have pasesetter LT's, ORY, and LM2 exhaust on my Formula. I think it sounds really good. Borla also sounds good, but I like to be loud(er).

- Mike

[BluBeaSSt]

I would rather have the Borla any day of the week

SLP parts=Junk!

[IronOutlaw]

Id keep the slp personally. I just dont like the sound of borla mufflers for somereason. It should sound deeper though and probably a good bit quieter with the plates closed.

[lethal93ta]

I had loved my borla cat back when I had the I have XR1s now tho Im going to put on for the new set up.