30" tall tires too tall?

[95sicknastyss]

So i wanna put 30" tall drag radials under my car but is it too tall for stock height? if so what needs to be done to fit them? thanks

[dsmawd350]

mini tub

why do you want to run 30'' tall radials?

[1963SS]

To be able to drive in the snow in Washington, DC.:D

[Phstratton]

To be able to drive in the snow in Washington, DC.:D

Lol! Skyjacker Camaro ftw!

[96lt1m6]

Ed Wright and Rick Abare run 30" talls out back,do you have abunch of gear and motor to justify
http://www.gmhightechperformance.com/features/0708gm_gm_performance_cars/1996_pontiac_trans_am.html

[SGT_WRIGHT]

From what I have seen, 28 is a bit of a squeeze on a factory height rear. I didn't want to take any chances, so I'm running a 26x10.5x16.

[95sicknastyss]

i want 30" cause i want my car to have the raked stance. i figured a mini tub would be required then i can run a wide ass tire. plus i think the profile height of my tires are too small and look funny. so with a mini tub, do i have to chop my rearend down any?
24742473

[96lt1m6]

PM fastfatboy he is mini tubbed
you can get the same rake with 28" tires and it kinda hurts MPH on the other end though

[dsmawd350]

PM fastfatboy he is mini tubbed
you can get the same rake with 28" tires and it kinda hurts MPH on the other end though

I'm also mini tubbed. It doesnt require you to narrow the stock rearend. just opens up the wheels wells for a bigger tire. Narrowing the rear will just allow you to use better offsets and get the deep dish look most like

[claysdad]

I run a 295/65 on my car with factory tubs. The fenders had to be clearanced. The back of the car is also lowered to sit down over the tires.

[badfnta]

personally 28's are as big as i would go unless you are have good gearing and some big hp/tq

[95sicknastyss]

i want my rearend to look like the pic in clays sig. thats the look im wanting exactly!