- procharger guys , keep SHREDDING belts.
- Fuel pressure spike, then rough idle
- forgive my stupidity
- Turbo questions
- Piston ring gap
- need a lil info
- More Intake Porn!
- Would you 175 it on pump gas
- Mallory 685 to MSD harness wire colours
- The nitrous works ?
- Nitous Install Pics
- 125 shot wet?
- Nirous plugs?
- ignition box decision
- Another LT1 Boost turbo build
- Intake Elbow with Nitrous port cast into it?
- wet or dry
- House of Boost Bracket kit?
- supercharged 383 questions
- Best solenoid
- Best plugs to look at to see if the car is lean?
- First shot after install..
- cc305 and nitrous?
- Nitrous Dyno Results
- Added a little shot to 1hottcamaro's AI H/C LT1
- Turbo engine build question
- TB sticking open some after 10 Lb of Nitrous
- intercooler
- New turbo kit for the Shop car
- Fuel pressure question
- Calling CALL911
- Trans Am Horizontal FMIC
- car turns off after d1 install
- Out of Nitrous Again!!!!!!
- ?
- Bad Luck w/ fresh blown motor
- Holset HX40 turbo...opinions
- Tuning issues
- ss air induction
- Larger TB for FI
- NEED FAST HELP!! F1A WON'T FIT!
- question about building a 8-10 psi motor
- could i make??
- water to air intercooler
- MoeHorsePower...please chim in
- Nozzle positioning.. Need opinions (picture inside)
- Should i spray my supercharged LT1?
- LT1 Boost Customer dynos his car
- Turbo Cold Side Piping Question
- Relay question
- spray or custom cam setup
- Biggest bore you should go with... with F/I
- Dedicated fuel system for nitrous.. A few questions
- Some LTx devastation we are responsible for!
- Just to give you guys some Ideas
- Map sensor for boost
- Finally done and cleaned up
- Knock sensor issues?
- found zex instructions for lt1 got a ???
- link to lt1 zex instruction in case someone eles needs them
- Nitrous Outlet LT1 plate & TPIS 58mm, mechanical art, it begins!
- ok to spray after cam install untuned?
- turbo hot side piping?
- Looking at low boost build - Input please!
- Motor build for nitrous ?
- Fuel pressure with turbo
- Rotating assy for a change of plans
- bogging on the hit
- new to turbo charging, looking for help
- worth the money??
- Going boost :(
- STS turbo help
- Blower Cam Specs - Mine too small?
- Going from Super to Turbo
- To Pulley Or Not To Pulley...THAT is the question...
- be more sneaky
- Boostin my BIRD
- PIC OF SOME OF THE WIFES HANDY WORK
- Bypass valve exit location?
- LT1 Turbo Cam -- Is This Good?
- Painted my Nitrous Bottle
- No2 cheap?
- Nitrous Outlet 10% off Speed Inc + Free Shipping
- noob questions
- FFF Turbo Crossover Pipe
- i think i made a boo boo. need a second opinion or two
- Pistons and compression
- Compucar LT1 plate. Need some input please
- LT1 Boost customer build - another one
- comp cams. 07-468-8
- Am I missing anything?
- curious about FI setup capability
- ZGOBYBY's Teardown and Build Thread - I Want Your Thoughts and Opinions!
- Going FI with high miles
- would it be a good idea
- Need sugestions will motor/ blower build
- New LTX twin turbo kit coming soon
- LT1 Boost TT buil;d for a customer
- Turbo Recommendation for my Build - Please Review!
- new nitrous product.
- Torching bottles.....BAD IDEA.........Please step inside
- Camshaft Options
- 95 Camaro RWHP?
- plumbed the manifold
- LTXTech Nitrous fast list
- help deciding a turbo
- 1994 z28 sts style boosted 7.5lbs DYNO
- Oil Catch Can setups...
- Air To Water location?
- Back in black! Almost back together!
- Which plugs
- zex kit
- Nitrous Outlet.
- blower cam choice?
- Vortech supercharger with procharger innercooler
- ???
- My Front Mount Turbo Build (TONS of pics)
- Force induction 101?
- FI Build Idea
- Our New Boost Referenced FPR!!
- Spraying a 6spd lt1
- Stand alone unit?????
- LT1 vortech pulleys
- LT1 Boost Update
- Do you think this will yeild more boost gains?
- LT4 and supercharging
- Procharger Build....Give Me Your Input
- log manifold guys
- Will it hold 25lbs?
- turbo brands
- Zex window switch wireing with msd box
- Mr_Bond turbo build, better late than never. 800+ HP or bust.
- help plz, nitrous jets???
- got an sts turbo for cheap!!
- Pictures of inlet setups on Prochargers?
- different styles/brand of Nitrous plate
- plat patern
- ac delco rapid fires and nitrous?
- 4 to 6 lbs
- my dream bottle
- I need to know what jets i need
- which side of nozzle does nitrous go?
- Custom Nitrous build Info Needed
- Another LT1 Boost Customer's Build
- 355 or 383
- POPOs TOP END build thread....
- Been a while but here is the latest build.
- what pistons
- single nozzle placement
- need help with jetting.
- build questions?
- LT1 Boost PT88 Build... another one
- No Bueno
- I never thought I"d see this day......
- Debating about selling the LT1 Boost shop car Turbo Kit
- Opinion me please!
- Supercharger vs Turbo Results
- Ok.....update time..
- Stock 97 z28 turbo
- dynoed my turbo motor today, horrible results.
- Hard Tubing Vacuum Lines -- Question
- LT1 Boost customer Roll Call!
- GMHTP Feature - Boosted LT1
- "The Slow Turd" S/C Build
- So how many of you (boosted) have done the EFI 24X coversion (I have questions)...
- Any interest in builder turbo kits?
- 355 with hot cam
- Turbo Hotparts build for Jason Short
- Need help! How far can I go?
- Nitrous window switch
- 1995 Z28 rear mounted turbo set up questions
- Best head gasket for nitrous
- Off the Shelf cam for SC build?
- Finally making some power! dyno video inside
- Bottle mounting
- Probe 12334-040 Pistons
- tuning problems
- nitrous wiring diagram
- Affordable BOOST....
- Ring gap
- Id give it a try!!!
- Look what I just scored on ebay
- spark plug gap?
- Questions about nitrous
- finished my new twin turbo hot pipes today
- finished my new twin turbo hot pipes today
- Advice from PROs please...
- How much boost will my set up make.
- New Shop Car build
- Car popping on spray .
- E85 & N2O
- P600b
- v1 to v7 ysi
- Boost pistons? 2618 or 4032?
- 94 camaro front mount DIY job need help
- Cold Fusion
- limitations of stock pcm for boost levels under 15psi
- what size radiator is everyone using to replace the factory
- how important is gapping rings for boost under 15psi?
- Taking off Procharger need help
- intercooler piping unsure what to do
- Boosted impala backfires and oil in air piping
- Is there any interest in an affordable LTX turbo kit??
- Getting rid of the FMU?
- Supercharger kits.
- Is a Meth/Water injection worth it?
- need help with my build
- safe shot?
- Retard, 2-stage, etc.
- plate or nozzle?
- meth placement and opti vent placement.
- What do you guys think
- Turbo Drain
- Compression Ratio For a Nitrous Engine
- Pondering the idea of going back to go forward.
- LTx Boosted list?
- supercharger choices
- Can A Stock LT1 Be Reliably Boosted?
- Turbo guys come in, got some cooling parts ?'s
- gt45+lt1355?
- nitrous W/O timing pulled
- Ls7 supercharged 427 ( Golen Engines ) into a " Lt1 style " engine bay
- Supercharger -- Bypass/Surge valve vs. BOV
- Turbo build part 2...
- 200 shot should I be ballsy
- FMIC guys
- Vortech v1 any good?
- check my build list!
- Revising Procharger Intercooler System (Twins to FMIC)
- Bead Rolling.......
- suggestions/ideas please!?
- twin turbo at 28 psi is going up on a dyno on thursday at 3 pm
- Procharger guys!
- LT1 Hotside, wrapped?
- Blower questions
- Solid Motor Mounts
- fmic for t-trim. advise
- Boost questions
- looking for instructions vortech sc kit
- Winter Build gt47-88 383 lt1
- Exhaust question, are headers necessary in FI
- Ring gap for Street/Strip Nitrous?
- i figured i post a build thread for my winter list of stuff to do.
- sc with a bov?
- Vortec V-2
- turbo build progress report need input and ideas
- stock heads + boost
- whats a good turbo?
- i started on my engine bay clean up
- homemade sts