Become a ltxtech.com member, Click here to register!

Page 1 of 2 12 LastLast
Results 1 to 10 of 15
  1. #1
    InActive Member


    Status
    Offline
    Join Date
    Jan 2009
    Location
    pittsburgh PA
    Posts
    39

    Default 94 t/a-formula parts

    i stripped my 94 formula down this week and now i have a list of parts for sale. i have pictures also everything is obo and you pay shipping

    i have all the body parts.

    trans am spoiler i cut the wiring so that you get both ends of the plug to easily wire your formula for the third brake light. $75 obo for spoiler

    the drivers door has a good regulator and motor in it. and the glass is good too. but the track on the glass needs replaced. the rollers are broke. $50 obo for drivers door

    pass side door is all together ready to bolt up and get your door panel
    asking $100 obo for it.

    DS fender $50 obo

    PS fender $50 obo

    trans am front bumper had some damage when i bought it. i had it professionally fixed. you can see on the inside where it was repaired. no big deal
    sold

    radiator and fans for a 6spd
    $125 together or $70 a piece

    formula rear bumper clear is pealing off
    $50 obo

    i took the dash out. and steering column out both with good air bags.
    $100 for the dash $100 for the column $175 together

    center council without top piece
    $25

    trunk latch
    $15

    hood latch
    $25 one year old comes with release cable

    heater controls
    $20

    i will post more. need something just ask.
    i have all interior pieces. they are dark charcoal
    Attached Images Attached Images
    Last edited by ricknbird350; 03-09-2009 at 02:03 PM.
    95 T/A 383 Lt4 4l60e,ported heads,9.5:1 comp,holley 58mm TB,ram air,MSD coil,30lb svo injectors,255lph pump,long tubes,flow master,stock opti,crower blower cam,computer is programed by PCMFORLESS, just had bryan dyno tune it a couple weeks ago. did a nice job on it. runs strong

  2. #2
    InActive Member


    Status
    Offline
    Join Date
    Jan 2009
    Location
    pittsburgh PA
    Posts
    39

    Default

    MORE PARTS

    i have the gas tank with a walbro 255lph pump installed about a year old. tank is in good shape barely any rust.
    $100 obo

    bmr control arms need new bushings and repainted.
    $40

    brake booster and master cylinder
    $30
    Attached Images Attached Images
    Last edited by ricknbird350; 03-03-2009 at 08:42 PM.
    95 T/A 383 Lt4 4l60e,ported heads,9.5:1 comp,holley 58mm TB,ram air,MSD coil,30lb svo injectors,255lph pump,long tubes,flow master,stock opti,crower blower cam,computer is programed by PCMFORLESS, just had bryan dyno tune it a couple weeks ago. did a nice job on it. runs strong

  3. #3
    InActive Member


    Status
    Offline
    Join Date
    Jan 2009
    Location
    pittsburgh PA
    Posts
    39

    Default

    more parts.

    lakewood driveshaft safety loop
    50.00

    adjustable full length bmr torque arm in black hammer tone less than one month of use looks almost new. looking for tunnel mount one.
    330.00 new asking 275.00
    Attached Images Attached Images
    Last edited by ricknbird350; 03-08-2009 at 08:40 PM.
    95 T/A 383 Lt4 4l60e,ported heads,9.5:1 comp,holley 58mm TB,ram air,MSD coil,30lb svo injectors,255lph pump,long tubes,flow master,stock opti,crower blower cam,computer is programed by PCMFORLESS, just had bryan dyno tune it a couple weeks ago. did a nice job on it. runs strong

  4. #4
    LT1 > LS1


    Status
    Offline
    Join Date
    Jan 2009
    Location
    Buffalo
    Posts
    253

    Default

    Any wobble in steering column?

    PM w/ pics?

    windsofthor@aol.com
    -Tom

    '94 Firebird .M6. .Pacesetter-LTs.
    Some would say.. Full-Bolt-On status

  5. #5
    InActive Member


    Status
    Offline
    Join Date
    Jan 2009
    Location
    pittsburgh PA
    Posts
    39

    Default

    zero wobble. i never had one with wobble.
    ill send pics of it tomm.
    95 T/A 383 Lt4 4l60e,ported heads,9.5:1 comp,holley 58mm TB,ram air,MSD coil,30lb svo injectors,255lph pump,long tubes,flow master,stock opti,crower blower cam,computer is programed by PCMFORLESS, just had bryan dyno tune it a couple weeks ago. did a nice job on it. runs strong

  6. #6
    InActive Member


    Status
    Offline
    Join Date
    Jan 2009
    Location
    pittsburgh PA
    Posts
    39

    Default

    nobody needs any parts?
    95 T/A 383 Lt4 4l60e,ported heads,9.5:1 comp,holley 58mm TB,ram air,MSD coil,30lb svo injectors,255lph pump,long tubes,flow master,stock opti,crower blower cam,computer is programed by PCMFORLESS, just had bryan dyno tune it a couple weeks ago. did a nice job on it. runs strong

  7. #7

    Default

    A4 inspection plate, you know the piece that goes under the TC between the tranny and motor?
    1994 TRANS AM GT: A4,3.23 / Cai / Borla exhaust / Strano Springs / Koni Yellows
    ltxtech.com/forums/image.php?type=sigpic&userid=43&dateline=123810500  2

  8. #8
    Banned


    Status
    Offline
    Join Date
    Oct 2008
    Location
    Lockport, IL
    Posts
    1,188

    Default

    drive shaft and how are the U joints price shipped to 60441

  9. #9

    Default

    Got a steering wheel with radio controls?
    Why Halo Thar!!!1

  10. #10
    Banned


    Status
    Offline
    Join Date
    Sep 2008
    Location
    Joliet, Illinois, United States
    Posts
    811

    Default

    t top car driver A piller in dark gray mint with no holes drilled for pods???? shipped to 60131

Page 1 of 2 12 LastLast

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •