- Navigation
Results 1 to 7 of 7
-
10-20-2015, 08:36 AM #1
96 Trans Am with bolt ons - repair or parts $1100 obo
96 Trans Am; LT1, T56, fully loaded, monsoon, T-Tops. ~158k on the car and ~50k on the engine. I bought it from a kid who did a lot of nice work to it had the whole steering system, brakes, suspension, and rear end serviced so it was a well taken care of car for the mileage. He replaced the engine with a low mile one with supposedly 50k (you can tell it is a low mileage engine, it runs very good) and he also did some bolt ons to it. Then he put it into a tree.. Still has a clean title as it was never reported to the insurance (took it off the road then sold it). This car ran and drove mint, I just dropped the T56 swap out of it. I has..
Brand new condition pacesetter long tubes
off road y pipe
Mint Magnaflow Catback
Lingenfelter CAI with oem 1LE elbow
Low mileage great running LT1 engine
good 3.42 rear
NO T56 included. T56 swap parts were taken out of this car.
tan interior is in pretty good shape with the exception of a cracked upper dash pad and ripped seats
TA bumpers and hatch are in good shape
good t-tops
The car is actually pretty nice and has potential to be fixed and registered as clean car, but I'm assuming someone will just buy it for the parts. If I get enough interest in the parts I may consider parting out, but for now I'd prefer to sell it as a whole. Here is a link to all the photos I have of the car: http://imgur.com/a/28J3p
$1100 obo Located in Methuen MA thanks for looking!
Last edited by KLaBZ28; 10-23-2015 at 08:45 AM.
95 Z28 hard top - LT1, 4L60e, bolt ons, Yank SS3600, suspension, viking coil overs, 3.42 10 bolt, 3320 lbs - 12.304 @ 108.52mph 1.69 60'
08 Saab 9-7x - L96 6.0 swap, L92 heads/intake/TB, LS6 cam, LS9 springs, 7.425" hardened pushrods, CAI, 1-3/4" stepped LT's, catback, 4L60E, FTI 3000 278mm converter
-
10-20-2015, 10:26 AM #2LTX Master
- Status
- Offline
- Join Date
- Nov 2013
- Name
- Corey
- Vehicle
- 94 Camaro z28
- Location
- new hampshire
- Posts
- 575
does that mean you are 6 speed swapping your car then?? GLWS
94 Z28 M6, 383 LT1, McLeod Twin Disk, MGW, SLP CAI, Pacesetter LTs w/ORY, E-cut out, Spintech 2OTL, Strano sways, BMR suspension, Viking coilovers, Solomon tuned
96 Chevy K1500, 5.7L Vortec, 4l60e, 14 bolt, Volant CAI, Pacesetter LTs, Spintech 6000, b&m, 33s- DD
-
10-20-2015, 12:02 PM #3
thanks man! yeah I'm putting the T56 in my silver car
95 Z28 hard top - LT1, 4L60e, bolt ons, Yank SS3600, suspension, viking coil overs, 3.42 10 bolt, 3320 lbs - 12.304 @ 108.52mph 1.69 60'
08 Saab 9-7x - L96 6.0 swap, L92 heads/intake/TB, LS6 cam, LS9 springs, 7.425" hardened pushrods, CAI, 1-3/4" stepped LT's, catback, 4L60E, FTI 3000 278mm converter
-
10-20-2015, 12:26 PM #4Xtreme Member
- Status
- Offline
- Join Date
- Nov 2012
- Name
- Shaun
- Vehicle
- 1994 Formula
- Location
- Phillipsburg NJ
- Posts
- 7,249
Supporting Member@Ltconvert scoop that magnaflow catback
Sent from my SAMSUNG-SM-G900A using Tapatalk2021 Charger Scat 392
1994 Firebird Formula 381 stroker - Carrying the torch! - 9.90 @ 134.3mph on a 200 shot
The wrench/driver for LTConvert's 94 Z28- Ellwein 383/LE Trickflows/ D1SC / CPT Ultra Pro Race 4L60E
10.78 @ 125mph. Shooting for 9.99 for Frank Cahall!
-
10-21-2015, 02:43 PM #5LTX Master
- Status
- Offline
- Join Date
- Nov 2013
- Name
- Corey
- Vehicle
- 94 Camaro z28
- Location
- new hampshire
- Posts
- 575
94 Z28 M6, 383 LT1, McLeod Twin Disk, MGW, SLP CAI, Pacesetter LTs w/ORY, E-cut out, Spintech 2OTL, Strano sways, BMR suspension, Viking coilovers, Solomon tuned
96 Chevy K1500, 5.7L Vortec, 4l60e, 14 bolt, Volant CAI, Pacesetter LTs, Spintech 6000, b&m, 33s- DD
-
10-22-2015, 08:15 AM #6
I love the converter and auto but I think its gonna go soon and don't wanna wipe out the converter. Might sell it or keep it..
95 Z28 hard top - LT1, 4L60e, bolt ons, Yank SS3600, suspension, viking coil overs, 3.42 10 bolt, 3320 lbs - 12.304 @ 108.52mph 1.69 60'
08 Saab 9-7x - L96 6.0 swap, L92 heads/intake/TB, LS6 cam, LS9 springs, 7.425" hardened pushrods, CAI, 1-3/4" stepped LT's, catback, 4L60E, FTI 3000 278mm converter
-
10-23-2015, 08:47 AM #7
Now willing to part this out if I get enough interest in the other parts.. I didn't really want to part it, which is why I preferred selling it cheap as a whole but I got a guy that wants the engine.
feel free to make offers on the parts or whole car.
95 Z28 hard top - LT1, 4L60e, bolt ons, Yank SS3600, suspension, viking coil overs, 3.42 10 bolt, 3320 lbs - 12.304 @ 108.52mph 1.69 60'
08 Saab 9-7x - L96 6.0 swap, L92 heads/intake/TB, LS6 cam, LS9 springs, 7.425" hardened pushrods, CAI, 1-3/4" stepped LT's, catback, 4L60E, FTI 3000 278mm converter
Bookmarks