- Navigation
Results 1 to 3 of 3
Thread: What tools needed to check PR?
-
10-07-2015, 11:53 PM #1LTX Master
- Status
- Offline
- Join Date
- Nov 2008
- Name
- Enrique
- Vehicle
- 93 Z28
- Location
- Houston/Clear Lake
- Posts
- 615
What tools needed to check PR?
Ok, I know I want to buy the Low Tension Valve Springs. http://m.summitracing.com/parts/pro-66793
But the real question is which pushrod length checker should I purchase?
I was thinking Comp Cams 6.8-7.8 length pushrod checker.
http://m.summitracing.com/parts/cca-7702-1
My question is this the best and easiest pushrod checker to use and is this a good size to buy? I don't think I'll go over or under 6.8-7.8.
This is for a 383 and AFR 210 heads.
Thanks!93 Z28, 383, PI 3200, Strange 12 bolt, 3.73, Strange coilovers, suspension, and going 24X... for three years or so.
-
11-05-2015, 07:58 PM #210 Second N/A Club
- Status
- Offline
- Join Date
- Sep 2008
- Name
- Josh
- Vehicle
- 96 Z28
- Location
- Holden, MO (KC)
- Posts
- 2,867
That should be it other than a sharpie! Directions for checking PR length can be found on our page, there's a video and a step by step with pictures HERE.
-Josh
co-owner of BDBRacing.com
NMCA OC 9004
96, N/A 385, Holley EFI, Faceplated M6, AI TFS heads, LE SR cam, MWC Fab 9
10.16 @ 136 1.50 60'........still workin on that 60' shootin for 1.4's!
-
11-07-2015, 12:47 PM #3LTX Master
- Status
- Offline
- Join Date
- Nov 2008
- Name
- Enrique
- Vehicle
- 93 Z28
- Location
- Houston/Clear Lake
- Posts
- 615
Bookmarks