Become a ltxtech.com member, Click here to register!
Fastbird

Page 138 of 138 FirstFirst ... 3888128134135136137138
Results 1,371 to 1,377 of 1377
  1. #1371
    Xtreme Member


    Status
    Offline
    Join Date
    Mar 2015
    Name
    Dan Dalessandro
    Vehicle
    1997 Camaro Z28
    Location
    Troy,MI or Port Huron, MI
    Posts
    2,089

    Default

    Pump in and everything.

    Ran fine until it warmed up🙃🙃🙃
    It's honestly like it has a power lag. Afr just goes all over the place once it's warm. Maybe it's those old Bosch O2 sensors? I'll toss it on ye ol' scanner and see what the O2s are doing.

    The only codes other than Evap is p0332, knock sensor 2 low input.




    Sent from my SM-G920V using Tapatalk

    14.307@98.21, 2.155 60'

    97 Z28, M6 with stuff done to it. SHOOTING FOR 12s IN A BOLT ON LT1 BOYS

  2. #1372
    Xtreme Member


    Status
    Offline
    Join Date
    Mar 2015
    Name
    Dan Dalessandro
    Vehicle
    1997 Camaro Z28
    Location
    Troy,MI or Port Huron, MI
    Posts
    2,089

    Default

    New Delco O2s
    Cleaned maf
    Replaced burnt crispy wires with some old ones I had
    Vented gas cap

    Issues seem to be gone. In the area 12.5 afr WOT


    Sent from my SM-G920V using Tapatalk

    14.307@98.21, 2.155 60'

    97 Z28, M6 with stuff done to it. SHOOTING FOR 12s IN A BOLT ON LT1 BOYS

  3. #1373
    LTX Regular


    Status
    Offline
    Join Date
    Mar 2015
    Name
    Stormy
    Vehicle
    1995 Trans Am
    Location
    Washington
    Posts
    286

    Default

    Dan what are you useing to scan with?

    Sent from my LGLS990 using Tapatalk


    1995 Trans Am - CAI - TB coolant bypass - Performance Muffler - Poly mounts - stock LT1/A4 - 13.3 1/4 - 1.9 60 foot , driven daily. .

  4. #1374
    Xtreme Member


    Status
    Offline
    Join Date
    Mar 2015
    Name
    Dan Dalessandro
    Vehicle
    1997 Camaro Z28
    Location
    Troy,MI or Port Huron, MI
    Posts
    2,089

    Default

    I have a hand held scanner.

    Drove about 100ish miles today and had no issues.

    Now that the car is getting proper fuel... Boy does that gas gauge go down fast.

    Going to try and hit Lapeer next week

    Sent from my SM-G920V using Tapatalk

    14.307@98.21, 2.155 60'

    97 Z28, M6 with stuff done to it. SHOOTING FOR 12s IN A BOLT ON LT1 BOYS

  5. #1375
    Xtreme Member


    Status
    Offline
    Join Date
    Mar 2015
    Name
    Dan Dalessandro
    Vehicle
    1997 Camaro Z28
    Location
    Troy,MI or Port Huron, MI
    Posts
    2,089

    Default

    Ew

    14.307@98.21, 2.155 60'

    97 Z28, M6 with stuff done to it. SHOOTING FOR 12s IN A BOLT ON LT1 BOYS

  6. #1376
    Xtreme Member


    Status
    Offline
    Join Date
    Mar 2015
    Name
    Dan Dalessandro
    Vehicle
    1997 Camaro Z28
    Location
    Troy,MI or Port Huron, MI
    Posts
    2,089

    Default

    I decided it was time to put the fog lights back in
    I removed the bumper to make life easier and do some spring cleaning. Found 3 sockets, and a few nuts and bolts!
    Spoiler is supposed to be done by Tuesday. Can't wait! Fixing the taillights tomorrow.

    Sent from my SM-G920V using Tapatalk

    14.307@98.21, 2.155 60'

    97 Z28, M6 with stuff done to it. SHOOTING FOR 12s IN A BOLT ON LT1 BOYS

  7. The Following User Says Thank You to Dan For This Post:


  8. #1377
    Xtreme Member


    Status
    Offline
    Join Date
    Mar 2015
    Name
    Dan Dalessandro
    Vehicle
    1997 Camaro Z28
    Location
    Troy,MI or Port Huron, MI
    Posts
    2,089

    Default

    Weather's been beautiful so I did some cleaning yesterday. Engine bay and the passenger side door jams is next. Steaming the carpets too.
    I used meguiars wash and wax and a few microfibers.

    Also got the wing painted and installed. Any suggestions for feeding the wiring through?

    14.307@98.21, 2.155 60'

    97 Z28, M6 with stuff done to it. SHOOTING FOR 12s IN A BOLT ON LT1 BOYS

Page 138 of 138 FirstFirst ... 3888128134135136137138

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •