- Navigation
Results 1 to 10 of 24
Thread: Weld RT-S 17x9 and 17x10.5 ?
Threaded View
-
08-12-2016, 11:37 AM #22LTx Guru
- Status
- Offline
- Join Date
- Apr 2013
- Name
- Fred
- Vehicle
- 1994 Formula - SOLD
- Location
- Central NJ
- Posts
- 2,283
This is a T/A with the American Racing 17x11 45mm offset wheels in the back:
http://www.kellydrown.com/Personal-F...ites/i-bZdLcSx
To me it looks like the edge of the tire is outside the fender slightly. Not all that bad.
Now, if you want something really wild, check out these 19x13's with 355 tires...... yes, mini-tub.
http://www.camaroz28.com/forums/atta...b-355s-036.jpg
http://www.camaroz28.com/forums/atta...b-355s-043.jpg
In photos below.... yes rear wheel gap is huge. It's set up to clear 28" slicks, with Eibach Drag Launch springs that sit about 1/2" higher than stock.Last edited by Injuneer; 08-12-2016 at 11:39 AM.
SOLD - GONE TO A (VERY) GOOD HOME ! - 94 Formula A3+1: 381ci forged stroker - Callies Stealth, Oliver 5.85 billet rods, BME nitrous pistons / CNC LT4 heads / CC solid roller / TH400+GearVendors OD / 4.11 Strange 12-bolt / 300-shot N2O / Spohn Suspension / roll bar / MoTeC M48 Pro engine management system /a few other odds 'n ends.
Bookmarks