I installed from bottom too.

I was not trying to bash the lpp headers and y pipe,I was just trying to see if anyone else was having the same issues I was having. These are a great set of headers that slipped in fast and easy! I...

Yea, those tags are sharp. I have a huge cut from putting the spark plugs in too. But these headers do make me a little up set that I had to spend all that money and another 100 to get header...

I hope so, i just got my set about two weeks ago. They still dont have the lpp tag on them.

Any one have issues with lpp header flanges not being flush on heads? They where both so bad no gasket I put would prevent the leak, so I had to take both to a machine shop to have them resurfaced.

Heres some pictures of where its hitting on the rail.

Im going to pull th passenger side out and grind the rail a little and prob have to give the header a little dent.

The headers went in super easy but did anyone that installed lpp headers have issue with the passenger side header hitting frame rail and causing header to not bolt up flush and leaking?

I was just trying to track down the leak with out having to take the car to the shop and be out of a car for a few days. But since I cant find it and it may be internal, I will take it back and have...

I will have to take it back to the shop that built it to check the engine and crank.

Parts are getting wet while driving. I jacked it up and looked around while running and could not find a leak anywhere. Still to this day cant locste the leak that is getting on the tranny and rear...

Thanks I will look into that.

Hello eveyone,
I just noticed a big oil leak that is all over my t56 bellhousing and hitting my headers which I can smell it burning. Its getting all over the oil filter and starter gear which...

Not sure if this will works for c4, but i used it on my 93 fbody.

4th Gen Rag Joint Eliminator (1993-1997)

Eliminates the factory rubber-fiber rag joint which can degrade and introduce...

Pm sent

Thanks for the info, I will try these step when I get back from my tdy and give an update.

I tested the m port and Im only getting1.50 volts,I also did not see any breaks in the wires. Any ideas on why I am not getting 3-6 v?

I have usb aldl drivers 2.10 and will test the volts for the m slot tomorrow, once I get my multi meter back and let you know what happened.
Thanks for the info

2874028741

Alright guys, i have attached screen shots of my settings and files. i downloaded DA2.ads, DA3.xdf files from tunerpro.

http://www.tunerpro.net/downloadBinDefs.htm

The 8th one down IIRC.

i...

I have redownloaded the files and checked the ports and have them set to com4 and it says that the cable is working. But it just says connecting. Not sure if I am missing somthing but I cant figure...

I can flash the codes by using a pin but when I try connecting the aldl cable and using my computer I keep getting no connection. I will try downloading again from site and see what happens. Thanks

Hello everyone,

Wondering if anyone could help me out? I had a tune from lt1pcmtune made for my 93 trans am and she is running good, but i think she needs some adjustments. So i purchased usb ...

Im using the blue gasket, but I also used glue after it started to leak. i also tighten the bolts every now and then and have not had any problems since.

Here are two pictures, I dont have any more on my phone and car is at the shop getting differential looked at. Once I get her back I will post some more.