single nozzle placement

[zooguy]

hey guys I am going to be running a single nozzle kinda soon and have started wondering about the nozzle placement.

I want to do it in the bottom of the elbow kinda hidden. I was wondering about flow to both banks and the air flow through the elbow. i dont want to have the shot only hittin the passenger side. so any tips or knowledge would help greatly.

[zooguy]

i know that there has to be a FEW people here that run nitrous?

[turtle]

I do but my intake is straight no bend sorry I can't help my kit says 6 to 8 inches away from the tb

[95ImpySS]

I ran a single Nitrous Express shark nozzle 2' away from the TB (a bit far, but it was hidden well ;) ) What intake do you have? You can mount the bulkhead fitting in the bottom of the elbow just after the MAF. Have it angled strait down the elbow. You should be fine that way.

You can use 90* fittings on the fogger to help hide the nitrous lines. Try to make your lines from the solenoids as short as possible. Helps slow the delay of the hit. Also make sure the lines feeding the fogger are the same length. Helps keep the 2 liquids reaching the fogger at the same rate.

7855

[ksmyss]

I put my nozzle in the space were the donkey dong thing went. I had the 1le elbow that had the area closed off but it still has the mount flange for the donkey thingy. I put the donkey thingy back on and had the noids at the base of the radiator. Nothing could be seen unless you crawled under the front of the car.

[Joker Z28]

I put my nozzle in the space were the donkey dong thing went. I had the 1le elbow that had the area closed off but it still has the mount flange for the donkey thingy. I put the donkey thingy back on and had the noids at the base of the radiator. Nothing could be seen unless you crawled under the front of the car.

I kinda like that

[ksmyss]

I kinda like thatI had about half a dozen people look all over my car and never saw anything. Another guy knew I had it but couldn't find it till he crawled under the car.

[zooguy]

i like it too ... but i mounted my bottle between the rear seats ... so its kinda right there and hard to miss

[96lt1m6]

I am late to the game however my nozzle placement is roughly 6" away from the TB drilled and tapped into the backside of the MAF I am using an Ls1 lid assembly though. I will be installing a direct port system in the near future:)