LT1FirebirdSLP
08-04-2011, 02:06 PM
Well I am new to this forum, but have had my 1994 Trans Am for years now. I took apart the car awhile ago and foolishly lost or mislabeled stuff along the way and I am paying for it now. I have googled and forum searched but the results I found were usually just discontinued GM part numbers and if it came with specs, I had little to no confidence in them.
I am looking to get some new hardware, primarily for suspension and was hoping some of you guys could help me out. I'll number my entries so it's easier to respond. I am looking for bolt length, diameter and thread size/pitch.Thanks in advance.
1) K-Member to Frame (long bolts, qty. 4)
2) K-Member to Frame (short bolts, qty. 2)
3) Power Steering Rack to K-Member (qty. 2)
4) Lower A-Arm to K-Member (qty. 4, not sure if the horizontals are the same as the verticals.
5) Spindle to Hub (qty. 4 per side)
6) Motor Mount Clamshell to Motor (qty. 3 per side)
7) MM Clamshell to MM Receiver (qty. 2, long bolts w. nuts, 1 per side)
8) MM Receiver to K-Member (qty. 3-4 per side)
9) Wheel Studs (qty. 5 per side)
I have also tried referencing my FSM and http://www.shbox.com/. This hasn't yielded anything aside from 1 or 2 part numbers. Also ARP doesn't deal in suspension hardware. If anyone has any other resources for this type of information, that would also be greatly appreciated.
Thanks guys.
I am looking to get some new hardware, primarily for suspension and was hoping some of you guys could help me out. I'll number my entries so it's easier to respond. I am looking for bolt length, diameter and thread size/pitch.Thanks in advance.
1) K-Member to Frame (long bolts, qty. 4)
2) K-Member to Frame (short bolts, qty. 2)
3) Power Steering Rack to K-Member (qty. 2)
4) Lower A-Arm to K-Member (qty. 4, not sure if the horizontals are the same as the verticals.
5) Spindle to Hub (qty. 4 per side)
6) Motor Mount Clamshell to Motor (qty. 3 per side)
7) MM Clamshell to MM Receiver (qty. 2, long bolts w. nuts, 1 per side)
8) MM Receiver to K-Member (qty. 3-4 per side)
9) Wheel Studs (qty. 5 per side)
I have also tried referencing my FSM and http://www.shbox.com/. This hasn't yielded anything aside from 1 or 2 part numbers. Also ARP doesn't deal in suspension hardware. If anyone has any other resources for this type of information, that would also be greatly appreciated.
Thanks guys.